Hey yall I'm putting a 4.5" zone lift on my 01 xj by myself for the first time... anyways I'm going to put the front Springs on and I had to tap a 3/8 hole for a bolt thst will tighten down the bumpstop.it seems like it's tight but the bumpstops spins I think the threads I tapped may be messed up. up any ideas?
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
Front coils bump stop spinning
- Thread starter Mcmadman
- Start date
- Location
- Minneapolis, MN
Bumpstop extension on the axle ? A regular nut and bolt will work.
It did come with a washer that was getting pretty bent up but it told me to do 25 ftpds.and I was at maybe 20...I think I messed up the tap tho cause I started it twice and the other side worked great I just don't think I'm going to be able to fit the coil over the stop or a torque wrench through the springs....would it be ****ed up if I drilled and tapped it bigger?I'm heading to the shop after some hw in about an hour
Similar threads
