Super duty 05 + Dana 60 questions

For those that have used one of these axles for their XJ. I am wondering the build cost.. and what you bought for it for steering, knuckles, what hubs, rims adapters.. I know they run the 8 on 170mm pattern.. I have a 14 bolt for my rear end which is 8x6.5 pattern..

I have 06' Dana 60 and 10.5, iv been building

For the 60, I cut all the cast stuff off and welded on. Full artec industries truss, I sent my right side knuckle off to a shop in California for them to machine in a high steer arm

Due to the width of the axle, it's almost impossible to setup with coil springs, my plan has been ORI struts