Gunter
NAXJA Forum User
- Location
- Aurora, Colorado
So i had problems starting a few months back. removed the NSS and cleaned it and went to re install, and the threaded prongs broke off. any idea to fix? in the mean time i set the switch so the engine starts and laid it over by the heater fan till i figure it out.
my second point, if yours becomes a non start issue, as an emergency fix to keep you going, clean it set it so it runs and lay it up by the engine out of the way. and be very careful removing it
my second point, if yours becomes a non start issue, as an emergency fix to keep you going, clean it set it so it runs and lay it up by the engine out of the way. and be very careful removing it
