KEN ROBINSON
NAXJA Forum User
- Location
- MECHANIC FALLS,MAINE
did a s10 bastard pack,wanted 3 to 4 lift but got 7.i like it but drive shaft angle is real bad,like 35 degree angle.if i put 8 degree shimms in would it fix it.
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
MORE LIFT THAN EXPECTED
- Thread starter KEN ROBINSON
- Start date
KEN ROBINSON
NAXJA Forum User
- Location
- MECHANIC FALLS,MAINE
this is how it sits
- Location
- Minneapolis, MN
An XJ/S-10 bastard pack will give about 4 inches of lift with this recipe: XJ main/S-10 main/S-10 2nd/XJ 3-4-5. Whatever recipe you use, ditch the flat S-10 overload leaf on the bottom.
You will need an SYE, and to measure for the correct SYE shims.
You will need an SYE, and to measure for the correct SYE shims.
KEN ROBINSON
NAXJA Forum User
- Location
- MECHANIC FALLS,MAINE
doing a hack n tap
stang65
NAXJA Forum User
- Location
- independence oregon
what did you do for the bastard pack did you break down the s10 pack or just stick it in cause your center pin is off also
KEN ROBINSON
NAXJA Forum User
- Location
- MECHANIC FALLS,MAINE
left the main xj leaf,cut the eyes off s10 pack and put it ubder the main xj leaf with new center bolts
KEN ROBINSON
NAXJA Forum User
- Location
- MECHANIC FALLS,MAINE
i think it arch the main leaf so much it sucked it forword a bit,look at my shackles
