Heater issue...

95 xj, been searching the web, has heat but only on lowest setting, meaning it blows but switch does nothing..... Just n hr ago, replaced motor and resistor to have the same issue......just looking for some input before I replace things that aren't needed..... Fuses are good.....I heard the switch could be the culprit.....

Any and all info would be excellent!

Thanks! sean

Well there really isn't all that much left in the system besides the switch...

I'd pull the plug off the switch and try jumping between the sockets. If you can make the various speeds work that way, it IS the switch.

I am in the exact same boat with my '96.

While you are wrestling with this issue you may want to consider going the extra mile of adding relays in. Jeep didn't do us any favors with wire sizing.

Here is a nice write up on the subject: http://www.jeepforum.com/forum/f11/...blown-melted-resistor-switch-wire-fix-580627/