HELP!! Rearend bearing question. ASAP

So I have my axles out because I'm installing an Aussie locker and chromo axle shafts I was planning in changing the bearings and seals in the outer corners on the rear end I popped the seals out are the bearings press fit that's the question it's a 29 spline Chrysler 8.25 rear end

Yes and no
rhey are pressed in, but nothing a hammer and a block of wood cant handle

You dont need an actual press

I got a puller thing that was like a slide hammer with a T on the end where the top peice of the T would lay flat for inserting and then when you pull it out it catches on that part and makes a T. The Parts store lent it out to me for a deposit.

And then like Souske said I Tapped the new ones in with a peice of 2x4 trimmed down to fit inside the axle tube a bit because it goes in further than flush..

Here is my brief run down before i did it
http://www.naxja.org/forum/showthread.php?t=1083394

Post 73 on my build thread has a pic of my special 2x4 tool lol and a brief blurb about doing the bearings
http://www.naxja.org/forum/showthread.php?t=1080904&page=5

thanks guys i got it all squared away bearing puller and a slide hammer worked great