1996 XJ fuel pump assembly wiring HELP!!!

Was pulling the gas tank and it fell and ripped out the wiring out of the pigtail connector thats attached to the frame rail right above the fuel filter. Does anybody have a clue which color wires go in which hole on the pigtail. There are 5 wires. They come from the fuel pump assembly at the gas tank up to the frame rail and plug in. Need help Jeep no start

Sorry, I have the 95 and 97 FSMs, but not a 96.

You should have 5 wires,,,
Wires 3-2-1 at bottom of plug.. wire 1 offset to the right(lower)
Reading from Right to left 1-lower rt-dark green/red relay output
2-lower center-black/Lt blue--sensor ground
3-lower Lft Dark blue,,Fuel level sensor
Top
Reading Left to right 6-5-4
6 -upper lft-black -ground
5-center dark blue/white...low fuel sensor
4-upper Rt--open no wire

wire in # 3 position is 20 ga...rest are heavier ? 14 and 18 ga.

Hth

To avoid any problem
6,,,,,,5,,,,,,4
....3,,,,,,2,,,,,,1

#4 hole has no wire