CobraMarty
NAXJA Forum User
- Location
- PM me any questions
Has anyone used these? Do they fit? Does anything hit?
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
1" Lift Motor Mounts ?
- Thread starter CobraMarty
- Start date
ktm racer 419
NAXJA Forum User
- Location
- ROW DIALIN
I couldn't get mine in place. bellhousing hit firewall. then again my t-case crossmember may have been bent up about an inch or so too.
I was going to do it for trussed axle clearance at full bump.
I was going to do it for trussed axle clearance at full bump.
souske
NAXJA Forum User
- Location
- The land of competition
These are for the Wrongler guys that do body lifts
foxwar71
NAXJA Forum User
- Location
- Foxboro, MA
I remember a discussion about these years back. clearance issues arise from both the tranny to firewall and valve cover to hood
Bbasso
NAXJA Forum User
- Location
- South Carolina
Why would anyone in an XJ need those?
ktm racer 419
NAXJA Forum User
- Location
- ROW DIALIN
i figured getting my oil pan an inch further from my axle would be a good thing seeing that they have smashed together in the past, and help level my driveline with my 1" raised t-case crossmember.
CobraMarty
NAXJA Forum User
- Location
- PM me any questions
In a 'street' 2WD which is lowered, the oil pan will hit the axle tube when lowered way down. 1" lift motor mounts would give 1" more lowering before hitting. Instead of 'sectioning' the axle tube and notch/lower the center tube section.
