XJ to ZJ tie rod / drag link mod

I searched and didn't find the numbers so here I am.

What are the NAPA or equivalent p/n's for the ZJ drag link, tie rod and tie rod end that are needed to do the conversion ?

No OTK, just normal under type.

Thanks in advance.

i dont have part numbers, but you want:

- XJ passenger outer TRE (this is the drag link)
- XJ driver inner TRE (this is the TRE at the pitman arm)
- ZJ passenger inner TRE (V8 model, this is the tie rod)
- ZJ driver outer TRE (should be the exact same part number as the XJ TRE at the pitman arm)

you will also need 2 of the adjusting sleeves, you should have 1 on your current drag link.

This info has already been posted on this Forum. http://www.naxja.org/forum/showthread.php?t=944708&highlight=ZJ+Tierod

I would go to the Autozone site end looking them up yourself.
AZ has a better price on these parts than NAPA.

You will not need any draglink parts, just the Tierod, 1 adjusting sleeve, and 1 TRE.

You didn't search to hard then... lol. Look at post 7 in the above link. I posted the moog numbers there.