center pin bolt HELP

OK, I'm trying to install my Spartan locker and have the carrier on the bench.

Well seems someone before my tried to remove the center pin and drilled a hole down the center pin holding bolt.

Anyone have any idea's on how to get this thing out?



I don't even see enough material to weld a Allen wrench to..

I could run it open but than I'd have this brand new spartan sitting on the shelf.

No one drilled a hole in the center pin, Its like that on its own. Get a small punch and hammer it out. Should slide out with a few taps.

The bolt holding the pin in has a hole in it and can only come out 1 way.

It's a D30..

I've pulled more than a few D30 center pins. So I know how they come out and look.

My mistake..

Roll pin is what it is..

All others I've done have had bolts in them with no rear access..

I've had 3 bad, bad days in a row and today just has not gotten any better..

So its out?

It will be, I have to get the roll pin punches from work tonight...