Hub replacement question

Hey guys, Im getting ready to swap out my Hub Assy. Im looking at NAPAs web site and there are a few different sizes. Im good enough with a wrench to get most things done but I have no idea here. Anyone have any thoughts about these or know what length to use. Thanks

Its a 99 4x4 btw
1-1/2" Wheel Stud Length vs 1-1/8" Wheel Stud Length

http://www.napaonline.com/Catalog/C...01999+50038+2038004+27930&Ar=AND(P_RecType:A)

http://www.napaonline.com/Catalog/C...01999+50038+2038004+27930&Ar=AND(P_RecType:A)


http://www.napaonline.com/Catalog/C...01999+50038+2038004+27930&Ar=AND(P_RecType:A)

http://www.napaonline.com/Catalog/C...01999+50038+2038004+27930&Ar=AND(P_RecType:A)

The FAQ section is full of good Tech info including this -> D30 Unit Hub, Rotor, Brake differences 84-01

NAPA should be able to tell you if you have your VIN# Give them a call

westvirginia24976 said:

NAPA should be able to tell you if you have your VIN# Give them a call

Click to expand...

This is assuming the previous owner or a repair shop has not installed a different hub unit.

To avoid return trips to the auto parts store, identify the hubs and rotors installed on your D30. They may or may not be the same parts as when it left the factory in Toledo.

Tim's way is the way to go. When I originally went to figure out mine, the VIN still didn't confirm which were on there, it said earlier while I had the later setup on my Jeep and they were all original. Best way is to follow the write up and look at the rotors and/or hubs.

^beat me to it.

Thanks guys. Apparently I didn't search hard enough. I'm getting on this first thing in the morning. I can't wait to have a squeak free heep again.

Seconding Tim here, and noting from personal experience: Check what you have on both sides. Mine came from a previous owner with one of each type!