dana 30 seal kit

Hi. So i have my dana 30 all taken apart from a 1988 disconnect axle. I'm going to replace the pinion stuff with this is kit.
Is this the right kit -> http://www.summitracing.com/parts/RAT-320K/

Does anyone have the a link or part number for the axle seals? I have the carrier out and I would like to replace them.

The dana 30 was 3.07 gears and i'm going to replace with 3.55. I'm planning on replacing the bearings and shims on the pinion but not messing with the ones on the carrier. Is that ok?

thank you,

Nate

http://eastcoastgearsupply.com/i-1563563-dana-30-inner-axle-seal.html

this says for non disco.

Once you replace the ring and pinion gears, you really need to set up the gears again. I would NOT count on your new gears dropping in perfectly set-up with the original shims. Since it's an '88, and since you'll not want to be replacing stuff again soon, spend the little extra $$ and replace the bearings too.