• NAXJA is having its 18th annual March Membership Drive!!!
    Everyone who joins or renews during March will be entered into a drawing!
    More Information - Join/Renew
  • Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

how to remove bilsteins bar pins

jeepfreak1020

NAXJA Forum User
Location
Thornton
So I was getting ready to install my new bilstein 1500 and I need to remove the bar pins. I have just studs on my coil buckets so I don't need bar pins. Well I went to remove them and it pulled the bushing outt to. I can't get the bar pin to move. I feel like its molded to the bushing. am I correct or how do you get the np out so i can press the bushing back in and install them.
 
I had this issue with installing my 5100s. The bushing is molded around the bar pin so you basically have to get another bushing. AutoZone sells a 2 piece bushing that fit perfectly and I run it with my bar pin eliminators.
 
I never knew this...good info guys. Thanks for the heads up!
 
Back
Top