rockfrog
NAXJA Forum User
- Location
- Colorado Springs, CO
I have seen the full roller 1.7 rockers arms, budget not there for those. Does anybody make a set of stamped steel 1.7 rockers for the 4.0?
Last edited:
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
4.0L Stamped Steel 1.7 Rocker arms?
- Thread starter rockfrog
- Start date
Talyn
NAXJA Forum User
- Location
- Radford, Communistwealth of Virginia
not that i know of
O-Gauge Steamer
NAXJA Forum User
- Location
- Colorado Springs, Colorado
The aftermarker stamped steel units are factory ratio replacement only. No demand for 1.7s in steel as the roller rockers cover that.
Be advised though, if you go rollers, the valve cover will need to be spaced up 1/2" to clear the new rockers. Hesco sells the spacer.
Be advised though, if you go rollers, the valve cover will need to be spaced up 1/2" to clear the new rockers. Hesco sells the spacer.
rockfrog
NAXJA Forum User
- Location
- Colorado Springs, CO
Thanks. I was hoping that 401 or 304 rockers may swap over, seems like they may come in 1.7 ratio, but haven't checked.
O-Gauge Steamer
NAXJA Forum User
- Location
- Colorado Springs, Colorado
I believe that the AMC V8s use a different rocker entirely. But, due diligence... I went on Summit Racing and all of the stamped steelies are 1.6ers... For all of the AMCs.
