Measurement needed: Who has an IRO or Clayton track bar bracket?

H

hawk_sixsix

NAXJA Forum User

Location

L.I. New York

• Nov 12, 2011

• #1

I need to know the inside measurement between trackbar bushing bolt holes. In other words, I need to know how wide of a bushing/joint I can fit inside those brackets. Double-shear type, frame end, upper mount, to clarify.

Iron Rock Offroad appears to be narrower than Clayton; need measurements on both.

 

B

blubullett

NAXJA Forum User

Location

Modesto CA

• Nov 12, 2011

• #2

On Claytons site it says there is 2 5/8" instide diameter. It is designed for a 2.5 inch Currie Johnny Joint.

 

9

98cherokeedriver

NAXJA Forum User

Location

HI

• Nov 22, 2011

• #3

Bump. I'm looking for the exact same measurements. I'm considering both brackets so that I can replace the worn out heim on my Procomp track-bar with a Johnny Joint and a double shear bracket.

I'm looking at useing this joint: http://www.currieenterprises.com/cestore/product.aspx?id=3579

 

dukie564

NAXJA Forum User

NAXJA Member

Location

Aberdeen, MD

• Nov 22, 2011

• #4

That joint is a "narrow" JJ - 1 5/8" wide. The normal JJs that the clayton DS brackets are designed for is 2 5/8" wide.

The Clayton trackbar I have has a 2.5" JJ on the frame end (2 5/8" mounting width) and a 2" JJ on the axle end (2" mounting width).

 

H

hawk_sixsix

NAXJA Forum User

Location

L.I. New York

• Nov 30, 2011

• #5

So who's got the measurement for the Ironrock double-shear bracket? It looks to be about 2", I need to confirm this before I order one.