Tracbar build help

Ok so i have gathered all the bits and pieces for heim steering. Going to do a OAT and build a custom tracbar. My OAT mount from JCR and uni side mount from RC both have a 1 5/8" wide opening with 7/16" bolt holes. I contacted Ruff Stuff about RH and LH heims. They don't have anything with spacers that will fit a 1 5/8" opening.. I also tried RC. They have a RH heim these Dimension, but no LH. Any thoughts on where to look next? Thanks

Use the rough stuff heims and misalignment spacers. Have someone put the spacers in a lathe and cut them down to the correct width.

Hmmmmmm I guess i could. I would also have to drill out the holes for 1/2 bolts. Ruff Stuff heims with misalignment spacers don't reduce smaller that 1/2.

You can get whatever bolt size you want. I run 1/2.