• Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

Radius arm clamps?

Nick_n_ii

Nick_n_ii

NAXJA Forum User
Location
Shelby, Ohio
Does anyone make a aftermarket Radius arm clamp for the late 70's HPD44 with the wedges on it?

Planning a build and want to build custom arms with the Ford style clamps..

Thanks
 
I just used the factory ones and cut and welded them. No problems. I even wristed the passenger side.
 
No, they are cast and you can weld to them fine.
 
No. I have welded several.
 
I am running a 78 Bronco front axle with modified Ford radius arms. It works sweet and was about a cheap a D44 as you can get. I've run it for years.
 
Are the bolt patterns going to match. Mine was from a Bronco, so it is a 5x5.5" pattern.

You are aware that you can get C bushings that have various angles.
 
Yes I know about the bushings found those in searching a few days ago..

Bolt pattern.. Right now the D44 is a 5 on 5.5, the FF60 is 8 on 6.5

I'll be hunting down all the parts to convert the D44 over to 8 lug. Seems around here the Rims are cheaper. And I just plan like the look..
 
You must log in or register to reply here.

Similar threads

G
Braided Fuel Line/Fittings Size From Quick Clip to Rail
Replies
2
Views
1K
GraniteCow
G
G
Radiator/water pump hose clamp sizes
Replies
5
Views
1K
XJI6191
X
W
Newbie with an XJ
Replies
9
Views
205
Wander Motor
W
R
Is 2wd upper control arm mount(on axle)the same on both sides?
Replies
7
Views
2K
Rallyrs
R
M
A few comments on RC 4.5" long arm setup
Replies
2
Views
3K
maxbraketorque
M
Back
Top