ericfx1984
NAXJA Forum User
- Location
- Kansas City Area
building some brackets to install some JK front upper and lower control arms... HOWEVER... I am not sure what angle I should shoot for...
I am at 4.75" of actual lift...
from test fitting I can keep the arms pretty close to the frame and end up at 5°
or I can lower the arms a little bit (around 3" below the frame rail) and end up at 0°
I know 0° at resting is optimal, however it lowers the arms a lot!!! so what do you guys think I should do?
NOTE: the stock arms at 4.75" of lift are sitting around 15° WOW!!! :laughing:
I am at 4.75" of actual lift...
from test fitting I can keep the arms pretty close to the frame and end up at 5°
or I can lower the arms a little bit (around 3" below the frame rail) and end up at 0°
I know 0° at resting is optimal, however it lowers the arms a lot!!! so what do you guys think I should do?
NOTE: the stock arms at 4.75" of lift are sitting around 15° WOW!!! :laughing: