magimerlin
NAXJA Forum User
- Location
- Flatonia, Tx
OK I am not asking for numbers here. I went through all the threads I could find and read stu's write-up. What I have found worked for the disco axle housing side that is not machined for a seal is
Napa #11771
National # 40576S
both are the same part just two different brands
drivers side uses the factory seal. National # 710068
-------seal measurements for the 11771/40576S are-------
seal is meant for a housing bore of 1.996" (my actual unmachined inner tube was 1.98")
seal outer diameter 2.00"
seal shaft hole 1.188" (shaft size of 1 piece axle shaft 1.2")
seal width .25"
I read somewhere, after awhile of searching, to use two of them next to each other since they are so narrow. I did and have no issues. And I have never seen a post with the dimensions in it so here it is.
disclaimer----this is what worked for my unmachined axle tube as the 11800 and other numbers most sites are saying will work didn't.
Napa #11771
National # 40576S
both are the same part just two different brands
drivers side uses the factory seal. National # 710068
-------seal measurements for the 11771/40576S are-------
seal is meant for a housing bore of 1.996" (my actual unmachined inner tube was 1.98")
seal outer diameter 2.00"
seal shaft hole 1.188" (shaft size of 1 piece axle shaft 1.2")
seal width .25"
I read somewhere, after awhile of searching, to use two of them next to each other since they are so narrow. I did and have no issues. And I have never seen a post with the dimensions in it so here it is.
disclaimer----this is what worked for my unmachined axle tube as the 11800 and other numbers most sites are saying will work didn't.
Last edited: