old_man
NAXJA Forum User
- Location
- Loveland, Colorado
I am looking for a stock driver's side axle for a 78 Ford Bronco D44.
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
WTB: 78 Bronco D44 Drivers side axle shaft
- Thread starter old_man
- Start date
fireLt.
NAXJA Forum User
- Location
- Craig Colorado
I'll check my pile out at the shop Tom. I should have one.
- Location
- Golden, CO
Looking for a shaft??? I have seen one at a local boneyard, can be persuaded to pull it.
old_man
NAXJA Forum User
- Location
- Loveland, Colorado
Anybody have one? Still looking.
- Location
- Golden, CO
It was still there last weekend, and no, that is not a FSB outter...poor lil thang.
Last edited:
- Location
- Golden, CO
Saw a '79 FSB tonight, unmolested. That yard wants $53 for the shaft.
Frank Z
NAXJA Forum User
- Location
- Colorado Springs
Tom,
What is the length you need? (center of u-joint to end of splines)
I've got 1 Ford short side inner and if it's the correct length, it's yours for a hearty Thank You and a handshake.
What is the length you need? (center of u-joint to end of splines)
I've got 1 Ford short side inner and if it's the correct length, it's yours for a hearty Thank You and a handshake.
old_man
NAXJA Forum User
- Location
- Loveland, Colorado
I will do some looking. My spare is now in my rig.
old_man
NAXJA Forum User
- Location
- Loveland, Colorado
From cruising the axle sites and everywhere, I found a measurement. I don't know if this is the number you were looking for. 18.91. The total length is 28.6"
Last edited:
Frank Z
NAXJA Forum User
- Location
- Colorado Springs
Sorry Tom, no luck.
