quick "?" about full width drivs shafts

userbmx1315

NAXJA Forum User

Location

Dallas, NC

• Nov 10, 2010

• #1

will either of my shafts need to be shortened or lengthened?
4.0 auto 231 SYE running a front shafts as my rear.
i am at work so i havent measured yet

 

X1994J

NAXJA Forum User

Location

Herriman, Utah

• Nov 10, 2010

• #2

Which axles are you going to? Are you stretching the wheel base any?

 

foxwar71

NAXJA Forum User

Location

Foxboro, MA

• Nov 10, 2010

• #3

userbmx1315 said:

will either of my shafts need to be shortened or lengthened?

Click to expand...

userbmx1315 said:

i havent measured yet

Click to expand...

:dunce:

 

MoparManiac

NAXJA Forum User

Location

Amherst, NH

• Nov 10, 2010

• #4

foxwar71 said:

:dunce:

Click to expand...

x2.

Please tell me this thread is just a bad joke.

 

asp

NAXJA Forum User

Location

Westport, MA

• Nov 10, 2010

• #5

What u-joints do you plan on running at the axle-ends? You could have a full width Dana 60 with a 1410 joint or a full width Dana 44 with a 1310. Just something to think about. If you want to use a stock style driveshaft (read: 1310 u joint) with a 1410 yoke on the axle, look into the hybrid joints.

And MEASURE. That's really all there is to it.

 

userbmx1315

NAXJA Forum User

Location

Dallas, NC

• Nov 10, 2010

• #6

hahaha got you!!!!
really tired of working hahaha
my cycle time on these parts are long

 

asp

NAXJA Forum User

Location

Westport, MA

• Nov 10, 2010

• #7

userbmx1315 said:

hahaha got you!!!!
really tired of working hahaha
my cycle time on these parts are long

Click to expand...

Bah, :laugh:

Edited so I don't get an infraction, despite the fact that it was in good fun.