KJurasek
NAXJA Forum User
- Location
- Lafayette, LA
Does anyone know where to find these? I know they are new to the market, but someone must be offering them.
Are they worth it?
Are they worth it?
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
Dynatrac ProSteer Ball Joints
- Thread starter KJurasek
- Start date
Boostwerks.com
NAXJA Forum User
- Location
- Colorado
The last time I checked Dynatrac was still working on them. That was a couple months ago though.
Considering a balljoint is the last thing I'd want to fail on a lifted jeep (especially on the hwy) it should be a worthy upgrade. That is assuming the load capacity is indeed higher than stock.
Considering a balljoint is the last thing I'd want to fail on a lifted jeep (especially on the hwy) it should be a worthy upgrade. That is assuming the load capacity is indeed higher than stock.
- Location
- Bakersfield, CA
As far as I know there for D60's. You can buy them from Dynatrac or any vendor that sells Dynatrac products. And yes, they are currently available. We ran them in the last King of the Hammers.
jeeperjohn
NAXJA Forum User
- Location
- Temecula, CA
I couldn't find any indication on their site that they make them for anything other than the D60.
foxwar71
NAXJA Forum User
- Location
- Foxboro, MA
x2
I believe theyre starting to make some for newer JK44's and prorock 44's, but nothing for our little ball joints. on a D30, its hard to beat a good set of USA made units; spicer/moog/trw.
