? about angle iron

[Boulder_jeeps]

Is there a place that sells angle iron in colorado in 5-6 ft lengths?
Looking to weld to the rocker panels like a flush low profile rock slider.:peace:

[YELLAHEEP]

Den-Col. They're on Washington just immediately north of I-25. They'll cut it to the length you need. Among the better steel prices around too.

[Boulder_jeeps]

Super! I have heard of them but forgot the name. By the by thanks for the PM. Waiting to hear back from the guy on the drop brackets.

[formatt]

I like K&K.. they're a little cheaper, pay with cash and he'll cut 10% off usually and you can pick out the pieces you want.

Located out near the flea market off of I-76.
__________________
matthew - 96 xj
formatt fabrications
www.formattfab.com (http://www.formattfab.com/)

[Boulder_jeeps]

Went to K & K and went with 2" x 2" square tubing. Had it welded on last weekend. I will post pics soon. It really came out great.

[jdogg4]

how are you going to weld it to the rocker pannels? Just wondering because the inside of angle isn't square.

[Boulder_jeeps]

http://i91.photobucket.com/albums/k289/Brad_Denton/angleiron.jpg
This was the original plan with the angle Iron.

http://i91.photobucket.com/albums/k289/Brad_Denton/rockerDRsideside.jpg

http://i91.photobucket.com/albums/k289/Brad_Denton/rockerPScloseup.jpg

This is what I did. Including steel, sand paper, primer, and paint (duplicoat), it was just under $100

[Hillbillyman]

I would suggest K&K surplus for any and all types of steel. Decent prices and great guys to deal with.

Sliders look great.