Anyone have trouble clocking the clevis end on a double ended cylinder? If so how did you get it to work. I used all the shims that came with my PSC cylinder, and used them in every way possible. Still could not get them close. I will get some pictures up of my set up.
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
Clocking Cylinder Clevis
- Thread starter caglezxj
- Start date
Well sense my last post I finally got it clocked the same on both end. You have to have the right shims and a certain amount. Sense I work at a place with a machine shop I made some shims this morning. They worked very well. My front steering is now complete. However I found a bad ball joint. So you know what I am doing tomorrow. Have a good day guys.
