PDA

View Full Version : is this a RENIX flywheel?


avnsteve
December 22nd, 2009, 17:08
http://i48.photobucket.com/albums/f234/avnsteve/IMG_8689.jpg

http://i48.photobucket.com/albums/f234/avnsteve/IMG_8690.jpg

http://i48.photobucket.com/albums/f234/avnsteve/IMG_8691.jpg

http://i48.photobucket.com/albums/f234/avnsteve/IMG_8692.jpg

http://i48.photobucket.com/albums/f234/avnsteve/IMG_8693.jpg

http://i48.photobucket.com/albums/f234/avnsteve/IMG_8694.jpg

there are 20 teeth between each gap, so 3 gaps, 60 teeth

and overall on the starter ring there are 164 teeth

lawsoncl
December 25th, 2009, 13:35
Renix. An 89, part number 3300-2674 I believe.
http://arrc.epnet.com/autoapp/9107/chiltonimages/8674/86744g54.gif

MrSimon
December 27th, 2009, 21:32
I just had my tranny out of my 87 Renix. It only has four torque converter bolt holes in the flywheel. Yours seems to have at least six.

I don't know if that info helps you at all though.

lawsoncl
December 27th, 2009, 23:13
I just had my tranny out of my 87 Renix. It only has four torque converter bolt holes in the flywheel. Yours seems to have at least six.

I don't know if that info helps you at all though.

Your automatic has a flexplate (not a flywheel), which would indeed have 4 bolts for the torque converter and 6 holes for where it bolts to the crank.

This is a picture of a flywheel which would be used with a manual tranny. The threaded bolt holes around the edge would be where the clutch bolts on.

MrSimon
December 28th, 2009, 10:07
Your automatic has a flexplate (not a flywheel), which would indeed have 4 bolts for the torque converter and 6 holes for where it bolts to the crank.

This is a picture of a flywheel which would be used with a manual tranny. The threaded bolt holes around the edge would be where the clutch bolts on.

That makes a whole lot of sense. Thanks for clearing it up.