XJ=Fun
NAXJA Forum User
- Location
- Klamath Falls
I need a good shot of the cast iron part of the housing.
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
pics of disconnect style housing
- Thread starter XJ=Fun
- Start date
joe_peters
NAXJA Forum User
- Location
- Grants Pass, OryGun
What are you up to?
Are you talking about the cover? Do you just need some measurements?
Are you talking about the cover? Do you just need some measurements?
XJ=Fun
NAXJA Forum User
- Location
- Klamath Falls
No i need a pic of the sleeve, the one under the upper control arm mount on the passenger side it wraps around the tube....Does that help any? Im trying to get a good pic because someone very far away from me is pretty good with fabbing and welding and needs a pic because hes going to fab me up a bracket to relocate my trackbar.
joe_peters
NAXJA Forum User
- Location
- Grants Pass, OryGun
Ok? When you say "sleeve" are you talking about the skid that protects the vacuum motor?
XJ=Fun
NAXJA Forum User
- Location
- Klamath Falls
Actually nevermind that, here is the new question though. Are the upper control arm mounts on a disconnect style axle cast iron or steel?
joe_peters
NAXJA Forum User
- Location
- Grants Pass, OryGun
Without looking, strictly from memory, they are mild steel.
TomMcD
NAXJA Forum User
- Location
- Parker, CO
If no one beats me too it I'll get you a pic or three tomorrow.
bdiamond
NAXJA Forum User
- Location
- Wichita Falls, TX
On disconnect housings both are cast iron. On non-disconnect housings the driver side is cast and the passenger side is mild steel.
