PDA

View Full Version : t & t customs

attikas
September 28th, 2009, 19:26
anybody know of any write-ups on t&t customs long arm kit? i just got the frame stiffiners welded up tonight. will finish tomorrow. will try and start the 1st of next week on the long arm kit. just want to get a little more familiar with it.

any help would be good.

thanks


btw there appears to be a few built xj's out there. where the heck are you? all i ever see is wranglers

it appears that i am definatley looking in the wrong area.:tears:
DrMoab
September 29th, 2009, 00:33
Clint, XJeeper and I all run them. What would you like to know?

BTW...be prepared for a LLLLOOOONNNNNGGGG day of drilling holes.
attikas
September 30th, 2009, 11:12
well like i said, it would be nice to see a write up other than the stuff that comes with the product. i know there are others running the product, but theres always somebody out there that has found a better way to install.
DrMoab
September 30th, 2009, 12:20
well like i said, it would be nice to see a write up other than the stuff that comes with the product. i know there are others running the product, but theres always somebody out there that has found a better way to install.

I'm sure there has to be a write up somewhere.

I was going to do one when I built my jeep but after spending a day and a half drilling holes I was just too tired.
FitchVA
October 2nd, 2009, 05:38
I was going to do one when I built my jeep but after spending a day and a half drilling holes I was just too tired.

big-time ditto. i'm a picture whore and love to do writeups, but after drilling those holes, i just wanted the darn thing to be DONE.
IntrepidXJ
October 2nd, 2009, 07:08
big-time ditto. i'm a picture whore and love to do writeups, but after drilling those holes, i just wanted the darn thing to be DONE.

x3
MoabXJeeper
October 2nd, 2009, 13:21
When you install the arms do NOT overtighten the joints on them. If you overtighten it will not flex very well.
DrMoab
October 2nd, 2009, 13:32
When you install the arms do NOT overtighten the joints on them. If you overtighten it will not flex very well.

Only one set of bolts. The others you want as tight as you can get them.
Clint
October 8th, 2009, 19:10
Biggest thing is to make sure you have really sharp drill bits..