Putting on my Lift

Hi there i haven't posted up really because i didn't have a jeep yet but i now i am putting a 3" rusty's lift on my 92 xj i have ran into a problem. i got the front coils on and now when i go to mount up the stock lower control arms they don't line up. on the right side of the axle the mount is far behind the control arm and on the left side of the axle its infront of the control arm. i'm new to my town so I haven't met anyone and i am putting it on by myself. Does any one have suggestions on how to correct this problem with just one man?

~Jimbo

disconnect your trac bar and drag link if you haven't yet. then spin the axle til they line up. not too hard

welcome use ratchet straps, or a pipe wrench.
http://naxja.org/forum/showthread.php?t=1008722

i had someone pushing with their feet on the end of the axle. it was hard but it worked

thank you i managed to get it on!

~Jimbo

Bet that feels good. Good job!