SINCITY192
NAXJA Forum User
- Location
- Bronx, NY
"Bringing the crankshaft around to
zero degrees top dead center (TDC)
compression, I removed the cam sensor
and checked the hole in the vane
where it was supposed to line up with
the hole in the housing by inserting a
toothpick through both holes."
i copied this from a article i found searching for shut off problems and i really would like to give this a shot after i get it running again I know how to bring it to Top Dead Center (TDC) but where is the cam sensor located and where are the hole that he's talking about?
thanks in advance guys
zero degrees top dead center (TDC)
compression, I removed the cam sensor
and checked the hole in the vane
where it was supposed to line up with
the hole in the housing by inserting a
toothpick through both holes."
i copied this from a article i found searching for shut off problems and i really would like to give this a shot after i get it running again I know how to bring it to Top Dead Center (TDC) but where is the cam sensor located and where are the hole that he's talking about?
thanks in advance guys
