WJ Rod end on an XJ Pitman Arm...

Just wondering if the WJ rod end will fit properly into an XJ pitman arm...or are the tapers different? I'm asking because my new Moog WJ rod end is bad already after only 2 weeks. Setup: WJ Knuckles, JKS spacers, JKS rods, and Moog rod ends, and XJ drop pitman arm.

Tapers are the same.

The WJ TRE at the pitman arm does not have enough travel to support high angles or too much droop due to the way it's bent and designed.

Do yourself a favor and make a "1-ton" draglink using GM TREs.