View Full Version : Modified Tech Discussion
- In Cab winch controller installed.
- Fender flare options
- Bright yellow sludge in ccv system?
- Reese hitch
- Bad Hubs.....Again.....to much b.s.
- is this all i need
- knocking when climbing steep hills
- rear diff fluid
- HI-steer running tie rod behind dif?
- Hella 500 (driving of fog lioghts)???
- lift setup? 3 inch and 2 inch bb
- Removable doors on 97' XJ's
- what tools
- transmission
- need opinions on Kumho AT's
- Aal
- dana 30 vs. waggy 44 (searched)
- New noise?
- What lockers can hold up?
- jeeps gettin some work, got a few ?'s
- stress on control arm mounts while driving?
- clunk........
- Lift Installation PROBLEMS
- 31's
- M.O.R.E. Motor Mounts
- Correct wheel backspacing?
- Tire size issues Issues
- 9" LIMITED SLIP
- how do you like your crown vic disk conversion?
- Alloy Usa vs. Superior Gear
- RE6300 Long Arm kit
- 8.25 shaft removal with powertrax?
- Installing roof lights
- 1975 ford steering, odd ball stuff
- Hell Creek Suspensions
- Reverse Growl
- Joints For My Shafts
- RE1801 SYE Kit Problems on a 242?
- good front tow point?
- Help me pick an axle...
- daystar question?
- Spare mount
- bumper
- upgrading to 4.5 lift
- Longer front drive shaft?
- idenifying coil springs
- Humming noise
- Need help from coil spring experts!
- sye question
- Rust
- anyone have the instructions for...
- WJ knuckles/calipers with 5x4.5 Warn hubs ???
- Jack mounts
- Problems installing lower control arms
- Header leaking
- opinions on lift w/ stock tires
- D44 Build up front and rear questions.
- Just point me in the right direction...rocker armor
- New Rims on Stock Tires
- which wench in the wenching best
- winch wire size
- Tailgate light..
- Good cheap 32 inch tires(lol, as if it was possible)
- 31's on 2"
- Spring expanders..
- Secondary fuse block
- Bilstein 5150 vs 5100
- Upgrade The Front
- Header question
- Weird Front Noise
- Rubicon Super Flex 3.5
- knocking noise after installin JKS track bar
- Bolt Pattern?
- low pinion or high pinion?
- traction bar project progress (mock-up and fitting)
- Rubicon retainer plates for disk conversion
- 8.8 & Flowmaster
- choosing a CB radio
- Front end skid plate ?s
- MJ rear lift:blocks or AAL?
- TeraFlex "Long Arm" Kit
- Emissions Q...
- Best trackbar to use for my XJ
- Time for NEW shocks!
- Adj. CA's Need lock nut?
- Stroker
- 5/4 point harnesses recommendations
- c8.25 question
- Powertrax no-slip. What size is the check block?
- Ford F150 Coils <- Owner's Feedback
- RE 5.5" XJLA
- Guide to Searching!! *Update*
- My stereo killed my battery
- Anoyying Rattling
- will my.........
- sye front driveshaft
- Shocks
- 4.0l ho head to a non ho 4.0 block
- 4.5'' lift + 2 in spacer = ?
- Questions on C-Rok brace install
- Rear box portion- necessary?
- What budget front opton is best.....
- need clear answer on front one piece axle seals.
- shackles and drive shaft angle?
- AMC20 vs. D60 widths?
- What to bore TB with?
- Getting ready to buy BB1X, but from who?
- How did you mount your roof rack
- Going higher and disconnects
- Shackle Question??
- Front lift affecting rear d-shaft?
- most effecient way to clean an axle
- Will the DakPak settle any ??
- rock rails
- junk yard find!!! sweet!!
- Axle argument....
- which 31"s??
- Does this SOund Right ?
- Another Trac Bar thread although slightly less common than others...
- renix engine and computer
- Custom 4x4 Winch Bumper
- OX locker Lever mounting?
- Can this tire carrier be modified?
- installing steering knuckle
- Disconnects, JKS quickers or RE Gen2's
- CO2 and air tools
- Jonnie Joints
- Tach Signal Booster
- Dana 35 Rebuild question
- rusty's or procomp ( and a tire question)
- ax15 swap problems w/ RE long arm kit
- Jackgaurd
- 8.25 with ABS problem... (creating one)
- Plans Ive got...any major flaws?
- lower gears at highway speeds
- blown driveshaft u joint
- Lift kit
- going bigger??
- Another tire Thread and hoped to do a poll but cant figure out how
- home made booster pak?
- Timken part number
- spindle question
- 31's with 4.10's . What kind of MPG?
- Modifying cruise motor for hand throttle
- rock krawler long arm
- Lockers
- '89 XJ Lift, Ground Clearance & a Short Wife
- Aligning motor mounts
- HELP!! Installing JKS quick disonnects now! Torx bolt?
- wiring lights to turn off with ignition
- Staun Beadlocks
- Control arm drop brackets??
- Which locker for front diff.
- Bought a winch Warn M8000
- Radius arms minus one arm
- Going to order a Locker for the rear, but?
- 5.7L Mopar V8 (non-hemi)
- Injectors for performance?
- What U-joints do we need for rear?
- 3in lift plus lift shackles and 1.75" coil spacers
- newbie tranny question
- need help with misinformation
- 17" black rockcrawler type wheel??
- Inside my transfer case
- 17x8" 4.5" BS on a 6.5" lift with 35x12.5?
- Didn't make it back from the last trip!
- coil spacer and oem isolators
- Aussie locker in front in the snow.
- Buldge fender
- Hella 500 Install
- tranny swap
- disk brake conversion testing/thoughts
- rust
- Whats a good tough finish?
- Banks header Bad?
- got a D44
- sky crapper
- Guess I jinxed myself.....
- LCA removal for TNT y-link
- Bored my renix TB, some problems.
- To those with skyjacker 8" coils
- will these backing plates work? (disk swap)
- Aftermarket Trackbar
- Lift options..
- shackle hits bumper bolts
- detroit locker in front
- Push button ignition?
- Steering components
- I know, I know
- home brew lift sanity check, please
- How much weight should I be loadin' in?
- 97 Dome Light in 87 XJ
- home brew lift bronco coils/spacers
- Rusty's 3in lift question?
- 36's how much lift
- Front End Noise in 4WD only
- rear axle vent tube.
- J-truck/chero chief axles
- speedo?
- need to pass inspection, need your opinion/advice
- Drive shaft binding...
- D44 teraflex disc conversion????
- Might have done it to get new ones :D Need Tail--lights
- Go-Jeeps Headlight loom
- 97+ XJ, rear disks and prop valve
- some questions about long arms
- 31-9.50s.... anyone running them?
- Spring pad to pinion angle, D35 vs 44?
- Rear Disc Conversion
- Wiring A Horn
- Rustys 6.5" leaf pack vs. RE 4.5" with RE 1.25" shackle?
- Want to contribute to a 4Wheeler Magazine Article?
- Angle & Cage
- QuickLok Experience?
- Death Wobble With 2" BB
- Door armor, I can't find what I am looking for...
- Rear Cargo Seat?
- What is the yoke pattern Jeeps
- Camber/ bent inner knuckles
- In search of a top rack for xj
- Top rack for XJ
- Teraflex BB1X Question: Isolator or not?
- HELP! NO START obd codes: 11, 12, 43
- Door Hinge and Track Bar Fix with pix
- bar pin eliminators
- cheap shock extenders
- full traction shackles vs. others
- reversed leafs
- Bronco long arm setup
- front brake lines and proportioning?
- Dana 44 swap/Parts needed
- Axle stress: Is It the wdigh of the vird/ri #colbo, `r the blrcumfe"`nce of the tir$
- Durability of Stock XJ crossbars?
- exo cae v/ iterior tachng
- Dana 44 Truss
- shock length soub rhght
- rear degree shims?
- 1&quoD8 shack<` lift?
- too run a 32 inch tire on my XJ...
- Running two different tires.
- New Exhaust, rustys?
- driveline vibration with install of new lift
- what would be a good price?
- rear suspenion, full-traction leafs and fox
- Ordering your lift kit--
- locright
- Auto trouble
- Fuel injector problem???
- Dana 44
- Vibration??
vBulletin® v3.8.3, Copyright ©2000-2012, Jelsoft Enterprises Ltd.