View Full Version : Modified Tech Discussion
- Modified Factory Head
- Help give me counsel
- Replacement bushing for RE HD Track bar
- 3inch Leaf Packs
- 23-35% Better mileage with Acetone?
- What is Causing My Bad Vibes?
- Anyone runnin' the TSL Swamper 32x9.50x15s
- Adjustable track bar on stock suspension
- bumper fabrication question
- Lube it up
- Tcase drop- Where can I buy it?
- Should I use a SYE?
- wiring harness for '91 4.0 I6 HO
- Plans for the next few weeks
- Aussie locker installed.
- Who's running beadlocks?
- 99 intake(again)
- New Transmission Or Lift?????
- lift kits
- WJ conversion and gears done!!
- Leaf Pack Question?
- 2wd to 4wd conversion
- Wrecked my Cherokee...brought me here
- electric fans
- R&P part number question
- Lots of XJ Q's
- Ultimate cooling
- Backup Light Wiring - will this work?
- HD SYE shaft replacement-lock-up
- Opinion: Mile Marker E9000 76-50040C or Ramsey REP 8.5
- emergency budget boost
- Will I need axle shims?
- Transfer case help
- Need a Seal Part Number - Urgent
- 81 cj roll bar in my xj
- Rubicon Express 3.5" flex or 3.5" ride????
- Oil Slinger question
- Dana 30 carrier disconnect vs/ non.
- Ranger, S10, Dakota driveshaft in a MJ?
- dana 30 question
- Bumper ID via magazine
- Fit and finish rear bumpers
- SYE & FRT CV SHAFT
- 14 Bolt Rear... Will it work?
- MJ Height sensing porpotioning valve
- Tomkin Front Bumper
- Swapping in 8.8 into MJ
- Odd question about 32's
- Springs?
- Manually Disengaging Front Axle
- Shims for budget boost?
- High Clearance light front tube bumper/tow hook
- Question about a Dana35 rearend
- Couple questions
- to the people who run tires 35" and up.. need help finalizing set up..
- a-arm conversion
- which flowmaster?
- swapping 96 parts into an 87 xj
- 91 S10 Calipers on D30
- Hommade snorkel for carbed engine
- 242 sye kit
- Allowable torque on rod ends?
- Aftermarket Valve Covers
- OBW with 2nd alternator fab
- Truxxus 37 inch Tires
- best rear 2" lift
- cooling help
- Amplifiers and engine noise
- RE track bar hardware (RE1600)
- center cosole swap
- I need some pics to install a rubicon kit
- Need electrical relay help FAST!!!
- how does this look for a budget boost?
- Mid range loss
- Safari Doors
- Long Travel Coil Springs?
- D30 parts swap compatibility
- Axle strength questions
- How to trim leaving flares on? Anyone have any pics?
- Rear stud length with disc brakes?
- Lights
- Mounting a 60" Hi-Lift in/on an XJ
- Koni Shocks ?
- Suspension torque settings
- Shocks
- What shocks should i get?
- Emergency, Motor Mounts sheared, jeep is hurtin
- Undercarrige cameras?
- 8.8 conversion question
- No-slip into 8.25" posi
- Quick help please, rear DS questions...
- Got the re3.5 sf installed but...
- 3" BB
- leaf spring retainer clips how many?
- Tires Rub after rotating
- lift help and questions
- Inchitis- 4" OME/BB now I want 5+"
- 4.10's, a 5 spd, and 31s temporarily...
- Cooling System Conversion
- Ford Injectors
- 4340 Seals
- 4.5" lift...to SYE or not
- A 'Leftist'
- Need advice IF YOU KNOW JEEPS PLEASE!!!
- porc hd SYE opinions?
- Hack-n-tap Seal
- gas tank
- d35 pinion seal
- Brake lines & 8" of lift
- 14 bolt brake lines?
- tires
- weld the trac bar mount bolt
- drop brackets with JKS adj arms
- Orbital eyes on leaves
- vortec v6 engine swap writeups?
- Laser to line up pinion?
- Duel Exhaust.. it's amazing!!!
- D30 rotors
- What year was the D44?
- Drain valve/fuel tank...
- Making a winch theft proof...
- Looking for a 34" tire
- Ring ang Pinion Pattern Opinions??
- Factory vs After-market Driving Lights????
- Hitch install methods
- Which tire and wheel combo?
- 4.0 or 4.2 Cam?
- lift ???
- Dana 44 wheel bearings front axle
- Aftermarket Tach ?
- Track Bar ?
- Universal shackles work?
- lift
- Revolver shackles for rear?
- longer shackles and leaf's
- Routing the Exhaust to the Side
- throttle body spacer
- Alternator relocation
- Favorite Xj Backspacing
- CD player
- Teraflex d44 disc brake conversion kit
- Quick Add a leaf question
- Speaker Question/Installation
- D44 Knuckle Rotation Question
- 27 spline lockright (dana30?)
- Order my lift, shocks, lockers and snorkel and have a question (still)
- Noisey Control Arms
- 4.56 Gear install, ABS Question
- digital oil pressure gauge?
- gearing question
- gps
- rear bump stops
- check engine light goes on and off
- Bilstein part #
- Misc. engine bay questions
- Quick Disconnects hitting coil springs?
- coil buckets
- 97-01 Overhead Console
- Gauge Install Questions
- Serious Alignment questions
- hitch mounted tire carrier
- Expedition in Antarctica?
- Anyone need some new winch cable?
- AW4 & compression braking
- Need help with Powertrax
- Am I running too rich/too lean?
- Tire width benefit?
- MORE motor mounts problems getting them bolted up
- Roof Racks
- Anybody try Type "F" trans fluid?
- Bumper and winch... will it lower my frontend?
- throttle cable
- ABS replacement with older parts?
- Gear Oil Question
- hot coil? 88 xj
- Gear pattern/Opinions/PICS
- air filter mods
- RE1600 track bar problems
- the 44 swap continues
- Horn problem when starting
- XJ Software Hacks?
- Question about 2wd to 4wd conversion
- HELP...Which Front bumper to Buy
- Seedometer wont work......help
- Rough Country Dakota AAL
- tube steel doors
- e-brake ?
- Ever seen these wheel balancers?
- Rear Bumper ?
- Specific RE 3.5 poll/question
- Slight trimming, keeping the flares.
- shackles and spacers
- drawing to build front bumper
- Front inner fender metal work...
- 9" axle retainer torque spec?
- front left wheel clucking!
- Rebuild oem PS pump or save for PSC?
- Powertrax No slip with 33" tires
- Half doors coming along....
- Jeepin Outfitters
- hellas on your luggage rack
- Leaf spring ID bushing?
- exhaust cutting...
- Actual lift gain measurements...
- Auto to Standard Questions
- Non-HO 89 to HO 93 motor swap - fuel rail questions
- 44 front question
- RE or JKS
- will clevis hold??
- what are you guys using for bumpstops?
- Need some serious help with driveshaft stuff
- adjustable map sensor
- Upper Quarter Panel Guards??
- 6" lift, need some shock and bumpstop advice
- Need SYE help bad.
- I'm locked and now I have questions ;)
- Another bored TB question
- side terminals of battery
- dana 300 t case
- Another control arm length thread
- Drop pitman arm
- Installing this wench
- 3in lift with 32 on 97+
- Tera-Flex drum-to-disc conversion install question
- electrical mod question
- Thermoelectric cupholders
- Rustys 3" Kit arrived!!
- Dana 30 and 44 pinion yoke part numbers?
- help
- Mile Marker Winch and Hitch Cradle
- double cardan help.. i searched
- Interesting cooling system additive.
- Gas Tank SKid beef
- renix to HO t body conversion info news
- Bigger tires and Torquiness
- 9inch info needed
- Computer questions for tranny swap
- Ford 8.8 write-up
- shortest long arm?
- 4.6 is eating belts!!!
- d and c extreme 4 link
- Rancho 9000 RCX
- raising the idle... manually or automatically
- dual tailpipes....
- ford radius arms causing lean?
- 2.8/3.4 Exhaust
- Wiring KC Driving Lights
- Adding Overhead Consol Wiring
- What manual tranny & computer for a stroker?
- what type of draw bar needed for lift xj
vBulletin® v3.8.3, Copyright ©2000-2012, Jelsoft Enterprises Ltd.