View Full Version : Modified Tech Discussion
- ATLAS speedo question
- Ford Stub with Chevy Knuckle
- Gearing Question for stroker folks
- zerks for front hubs?!?
- Rustys steering/Chevy DRE?
- Disk brake conversion
- Rusty's Full Packs
- Which OME suspension to use: JC1B, JC1A or JC2A?
- 4" lift on stock springs and no blocks!
- Preparing for a lift, but I'm lost!!!
- Throttle body changes
- 32 Spline GKN Front Driveshaft swap-out?
- Over Axle Trackbar Bracket
- cv/u-joint strength
- H1 rim fitment to 3/4 ton ford front d44
- Chy 8.25,Powertrax No Slip?
- Help with building custom splash guard for K&N Filter (already tried searching)
- (Picture)Advice PLEASE long arm or ? what else?
- Installing a front locker...seal question
- Rusty's Steering Conversion TRE Part #?
- master cylinder line ??
- TrXus STS - Who's used on WEST COAST ROCKS?
- mx6 shock's
- Thoughts/Feedback
- HID conversion kit/lights
- really low gearing
- Homemade front tow hook mount?
- I cant pull my axle shafts!!
- Measuring Angles Qs , Vibes after 2"
- To mount normal shocks do i need this?
- Fender trim question...........
- larger oil filters???
- Homemade coil spacer?? help!
- please advise on these swaybar discos
- diff fluid getting pushed out of vent tube
- I have a question
- OK so what driveshaft?
- Dana 30 gear help
- Rearching main spring
- front axle joints
- brake lights??
- for 7" is a SYE needed on...
- D44 Brake Line question
- homemade swaybar discos
- Driveshaft measurement questions... with a twist
- How to shut up poly bushings
- Abs is gone new questions!
- Dis-Connect Fork options ?
- AirAid vs Snorkel
- Difference in hinges?
- Loctite red or blue?
- XJ rear Driveshaft questions
- angles on frame rail?
- Gear install write ups
- swapping out an 87 4.0 for a 91 HO
- Lifting the a$$-end of the hood
- t-case drop, vibe in front
- 300 for 4.5 Deavers?
- Too much lift
- Newer 2 DR glass in older model
- Exhaust - Once and for all
- onboard shower
- Transmission Cooler Install Question
- Quick $ q's...GC knuckles, etc
- Skid for claytons?
- on board air help?
- 242 to 231 swap
- can i use rubicon shocks on my xj w/a 3" lift?
- help! th350 tranny trouble!
- Locker, front or rear?
- ARB sucking up fluid
- Lock right vs. Detroit?
- 700r4 by jet on 4wd.com
- swapping a 4 banger for a 6
- quick question
- AW4 shift behavior
- tomken frustration
- Track Bar Questions
- 3" and 33's...picture's please
- TC lower, front angle higher
- Removing steel for LCA droop clearance
- Barrio Fabworks full-width 8.8 swap...
- Welding rear end
- 33s or 35s axle stress
- trying to buy a lift
- 1989 4.0 to 1998 4.0 swap
- cut doors
- 89 XJ to newer style front end and rear end
- waggy 44 prep
- UpCountry leafs and CarQuest coils
- 2 wheel drive WJ front axle parts?
- Help with 7100 valving
- convertible XJ?
- other mods
- What coils to go with?
- Front shaft?
- Chrysler 8.25 worth Locking?
- Which gears are better?
- front sway bar drop?
- Are your cages tied into the subframe?
- homemade axle disconnect
- super 35 kit...any good?
- longarms
- Tire question
- Seeking a new muffler.
- Ball Joints
- blocking air intake
- Trailer Towing - Stress on Aftermarket Components?
- About 3inchs of lift
- Doetsch Tech Shocks, what do you think??
- YJ Bumper conversion
- Why is this such a problem?
- Finished installing my D44 - few questions
- doors off ok?
- Long weekend project...
- No-slip locker or diff problem
- 97+ console in pre 97 jeep
- Flex-a-lite 110
- 4.56 vs 4.10 (d30/8.25) 97XJ
- Will a 92 HO head bolt up to a 88?
- tires and wheels
- converted closed to open with 3 row csf
- TC drop and driveshaft length
- xj dana 44 shafts.
- My custom intake and question...
- Death Wobble and Overheating
- Dual E-Brakes
- roof rack design/ideas/questions
- Track Bar Broke
- Pull to the right... power steering box?
- Project bumper recycle!
- E-brake extenders
- Homebrew Tie Rod Questions
- Will a GKN yoke/plate work with any other front DS?
- Longarms (not what you're thinking)
- XJ 44 under an MJ
- Canoe Rack?
- Extended Bumpstop lengths
- H&T & Front D/S
- 3.4 liter V6 in an xj
- Question and Opinion
- 2wd lift kits
- Building Radius arms
- Taking my doors off and i noticed something..
- installed spacers between the hinges and the hood
- B&M Transmission SuperCooler
- Will a 97 xj front bumper fit on a 92 xj?
- Changing from straps to Ubolts 8.25 D30
- Best tire for the job.
- spacers vs long conrol arms
- Fuse for interior lights
- control arm bushings axle side
- dana 44, dana 60
- Why no upper arms?
- Couple noob questions...
- Ticking/Clicking sound from front axel
- Inside diameter of D30 axle tubes.
- caster on 00' low pinion
- 89 doors swap with newer style 97-2001 ??
- D30 inner seal part #?
- IPF Headlights...
- axle shims, different types
- aftermarket P/S pumps/boxes
- LPD30 vs. HPD30
- 8.25 - Best Lunchbox Locker?? Opinions Needed!!
- shaving
- alignment ques
- OEM motor mounts suck…
- ford 9 inch guys
- axle swap..
- not a DW ques.
- full width 8.8 bolt pattern ?'s
- Coolers!!! All kinds of them...
- 5.5'' lift
- gear purchasing
- what material is the drag link made from?
- square tubing bending
- Can style air filters
- Custom Dashboard
- On Board Air queston?
- running a wider rear
- Bilstein 6100s score for only $20 but 6in travel
- D30 inner axle swap
- ZJ Wheels to XJ?
- Am I just getting ripped off?
- superior stub shaft part number
- Looking for front bumper manufacturer (see pics)
- empty dana 44 rebuild
- Anyone running turbo 2.5L ?
- Track Bar ends bolt torque?
- axle bracket q's
- Dakota 8.25"s and ABS
- 15" tyres verses 16"
- XJ 44 parts question
- d 30 front
- Gear pattern (Pics)
- Steering upgrade, check me
- steering box brace trackbar mount
- Ring&Pinion Pattern. How do these photos look?
- Rear diff cover seal issues- Help
- Who makes a 190F Thermostat?
- Rusty's Control Arms.. ADJUSTABLE
- Bushwacker Flares???
- Powertrax No-Slip Warranty/Parts?
- Anybody using Farm Boy Designs tail lamps.
- Track Bar
- agenda for 2005/06 what would u change
- jks extended brackets
- Exhaust
- Junk Yard Leaf Problem
- s10 leafs vs dakota leafs
- The perfect leaf spring shackles
- "Force Automotive" Pro-Series Muffler/Jegs stuff
- A pillar gauge pod
- Bump stops with ACOS's?
- xj on 35'
- BPE's and bushings
- Which Leaf should I remove?
- front coils for 91 cherokee 2dr sport
- t-case falling out of gear
- Cheroke A/C Rad for Turbo 400 tranny cooler?
- Will a set of 99 s10 leafs work for a lift?
- Will a 99 Dual Pattern Cam work on an 87 Renix??
- ??'s concerning SS boggers Anyone have 33/10.5/15 Pics??
- Rock Krawler 4.5 coil springs
- 34-35" tires...what else do I need to worry about
- "Full Traction Lower Control Arm"
- MASSIVE elec. problem after aux. fan switch install!
- Need HELP ASAP - JEEP apart on driveway - axle Qs
- Rusty's new rocker guards.
- What axle is this?
- Ultimate cooling
- tail lights
- Tom Wood's DriveShafts Baaaaaadddd???Need TW DS owners here
- 62mm TB whistles...
- Brakes still soft
- Heat tape on e-brake cable
- 1-ton XJ ?'s
- fenders, header panel optional?
- Front end traction...
- Steering box spacer thickness?
- nutzert to nutzert swap
- Hello I'm new & looking for Tow Hook advice
- Need source for good torque wrench to set bearing preload
- What would you rather get (if you had to)
- Question about the hack and tap setup..
- What do I need to know about 33's?
- my snorkel sucks...kinda
- RE Drop Brackets and Rocker Protection Problem??
- Are Beadlocks beneficial in Mud ???
vBulletin® v3.8.3, Copyright ©2000-2012, Jelsoft Enterprises Ltd.