View Full Version : Modified Tech Discussion
- Tire ???
- Tire ???
- Mile marker winches
- Netting 4.75 inches of lift
- Found a Dana 44, what should I replace the open carrier with?
- chevy 350 with a pic or two
- bushwacker pocket flares?
- Tie rod end Question
- Control Arms
- flares, 33's, conTrol arms, unibody
- flares, 33's, conTrol arms, unibody
- RE 3.5" Lift Question Question ????
- DIY Speedo recalibration..
- sye 97 up into a pre 97(ouch)
- convince me not to go to 5.13's
- Leaf Spring Bolts
- Ome Shock Length
- TIRE PRESSURE (what do you run?)
- Gear setup
- Modine or GDI Radiator...
- Tstat temp wiring question
- 242 to 231 Swap Question
- 2 inch cheapo lift
- anyone running H1 wheels?
- upper control arms
- Dual Oil Filters- Any real life benefit?
- Offset and 31's? Looks/Performance
- lower shock mounts
- What kind of Glue
- Funny tire wear- MTR's
- What kinda changes..
- Door Removing, with out cutting?
- Cheep Engine compartment cooling mod.
- Stroker??? 258 CRANKSHAFT
- which yj gears can I swap into my xj
- Clayton XJ (Rear) Coil Conversion
- axles
- Coil Spring bottom retainer clamp, advice needed
- Dana 44 Brakes ID
- Ford Bumper for 88 XJ!!
- 258/stroker crank
- Gear Swap - Check my pattern.
- home brew transfer case drop...
- Potential Problem
- Rubicon brake lines
- Where to find aluminum bumpstops?
- Bent RE trackbar?
- Rubicon Wheels & MTR tires
- 85 Xj 2.5 swap with a 4.0
- superflex joint looseness
- Need a quick answer-stereo wiring
- Got stuck...need some tips
- 8.5-9" Rusty's Coil Pics
- Lift time is here!!
- rubicon express lca size dom?
- Limits of TRE in stock steering set-up with 6.5 inches of lift?
- chevy 44 trackbar mount
- external slave swap questions
- Building Bumpers...i need help
- Turn a Tranny cooler into a Oil cooler?
- transmissions options
- Temp Gauge Inaccurate?
- Skool me on D44's
- OME vs Bilsteins What's the diff?
- Transfer Case Q. - Temp
- Tow hook options....
- Shackle help
- AW4 cooler line upgrade
- 3" Procomp... but need a littl more
- milemarker/speedo calibration [windbag edition]
- Jeep won't start, no spark
- Carrier damage after snapping an axle shaft
- Flowmaster Question/Opinions?
- Rustys HD Trac-Bar Package
- What would make my Jeep sag on one side?
- C 4x4 Front Bumper Owners
- At what price would you buy a Super 35 ?
- Trimmable Bumpstops?
- Does anyone know of a Buying Tips FAQ?
- Mj No-slip
- new front hitch! How to get bumper off?
- Tow bar for Cherokee
- 4.0 Non HO to HO Head Swap
- How much lift
- Starting Problem
- revolver shackles?
- Trackbar limiting droop
- death wobble (yes ive searched....alot)
- Front Leaf Spring Bolt ( I searched)
- Think this would work?
- Rebuilding Superflex joints
- Sway Bar Disconnects
- pattern check please
- what lift?
- 97+ bushwacker rewrite up
- sye help please!!!
- Junk Yard Stuff: Tranny Cooler + Skid
- Possible Tranny Problem?
- Ok Ive made my mind up
- Dana30 mix-n-match delima
- Nut Strips and Rear Hitch
- Bolt grade
- Hd242 T/c
- vacum disk D30 shafts in a non vac disk D30
- Rockkrawler Warranty???????
- misfires after lift install
- 2.8 to 3.4 swap
- Problems w/ IPF X51 Fatboy Bulbs
- 3-Jaw Puller for removing Carrier Bearings?
- Downpipe gasket leak?
- speedo on 231 question
- pitman arm with LESS drop
- Black Ooze coming out near Front u-joint
- removing rear shock bolts
- CRASH / GOATMAN: More Dana 44 questions
- carquest XJ coils
- Walmart Liberator A/T (yet another tire question)
- 8.8 axle pinion angle help...
- rustys steering conversion ?
- Ramsey 12000E Winch...
- !!Factory T-case Skid!! HELP?
- smiley tools welder/plasma cutter
- 16" rims for an XJ
- Best Price for 4.5" Leaf pack?
- 4.0 Waterpump suggestions?
- To all those running Bilstein 7100's
- Aussie locker review "dana 44"
- np 242 to np231 swap Q's
- 16" wheels = larger brakes availble???
- I need ford 8.8 specks
- ready welder
- is this anyone here?
- Gear problem after locker install
- deaver, national, or alcan?
- Tire question, I tried searching
- Rear diff fluid and friction modifier?
- Which Posi Lok with RE 5.5 XD lift?
- Acos and 5.5 RE lift?
- Drop Bracket vs Long Arm
- AJ's OFFROAD ARMOR KUDO
- Has anyone actually overheated?
- pinion nut
- Will D44a discs work on a D35
- New to the XJ. Have Noob Q's
- Need help with lift question
- I'm looking for Big Red that sold a bunch of Labaron hood vents
- Formattfab Tube Doors
- Need help/questions regearing 97XJ
- Rear leafs not moving
- Catalytic Converter Question
- Lowered the jeep
- full width 44 in xj....need pics/help
- How to tell the difference in u-joints
- Dana 44 axles (s)?
- Night And Day
- Budget Rear Bumpstop ideas?
- factory winch mount
- Dana 44 question
- Link / lift question
- 3 inches off, the axle or the technician?>>you tell me
- exhaust
- So, I got an alignment and...
- FlareLess
- pinion length 8.25 vs dana 35
- 05 f-250 axles, what next
- What have I done!?!?
- I lifted my XJ,how do I lower the transfercase?
- Ford 8.8 Build Up Q's
- New springs vs pinion angle?
- Crossover Steering Done [pics]
- best rebuild
- ssr super swamper radial
- I have everything, ready to do the lift..
- What brand/type of injection pump does an XJ Diesel have?
- Ac delete belt?
- Butt Job
- How do I measure for correct shock length?
- Isuzu 44 "thick gear" yoke
- The optimum setup: Tire Size, and Lift for all around versatility.
- Homebrew diff protection
- AJs Offroad Armor front bumper design Competition
- Arb bull bar and warn winch install
- home fab track bar
- new home fab bumper
- Merce-Jeep photos
- Bearing Removal
- AAl vs. Shackle
- pitman arm removal
- question about dana 30 axle shafts
- axle welding?
- Shock Specs, RE 5.5 LA
- Tire info
- washer bottle swap
- slip yoke eliminator and a new driveshaft
- 87 to 89; difference in hp.
- e-brake light
- Ever used HAMMERITE?
- What are the best sping keepers?
- 134a retrofit question
- Disco Length
- sway bar rubbing
- Got 2 of the skids, hitch, and discos on today....
- Rockkrawler Springs
- mud dawgs
- Rustys In-Cab Rollover Bar
- JKS Shock Adaptor Question.
- Hitch and skid plate
- omix ada leaf springs
- Those with RE/Clayton combo LA's.
- where would you get...
- transfer drop, not what your expecting
- Anyone seen a curved needle for a grease gun?
- crossover tube
- Sun Roof?
- Could this be an easy fan conversion?
- tire ?? v. 11tybillion....
- reed switch anti theft system (ADE)
- MJ with YJ tranny/clutch...??
- Pinion Shim location
- Leaf spring install problem (long)
- motha truckin death wobble
- Tomken skid ?
- Need an adjustable track bar with RE6030?
- Gas mileage drop with 30's? And will they fit?
- Hydro assist?
- Great lift combo
- shift knob
- Best insertable locker for rear D44
- pittman arm
- steering / lift / skid plates / bumpers / brakes
- lift thoughts
- Adjustable LCA's and UCA's at 3"?
- Carrier questions
- Diff cover fill hole
- help w/ lift
- Sucessful Dakota lift!!
- Rusty's Rear Brakeline Extension...
- Spooled my lockright
- really quick tire question
- Heavy Duty Cooling System
- coil spacers
- xj lift question
- shackle help
- Rock sliders installed
- XJ to MJ seat conversion
- Sway Bar Drop Brackets
- My D44 build with 36" IROKs, tested and it works!
- Sliders that dont use pinch seam
- xj pitman
- D30 ring and pinion question
vBulletin® v3.8.3, Copyright ©2000-2012, Jelsoft Enterprises Ltd.