View Full Version : Modified Tech Discussion
- currie 9" with discs in the mail
- 33x12.50's with 3.07's
- Redoing the brake lines
- dist. indexing/ too much cam/ or both- need suggestions & opinions
- alloy inner shafts, plus hot, naked women!!!!
- 38's on a cherokee????
- Dana 30 axle tube seals
- ARB Bullbar OR Custom 4x4 Front Bumper
- bead locks
- ATTN: North Atlantic Chapter
- axel upgrades
- Measurement from center to center of coil bucket???
- 6 or 8 lug
- rusty's lift?
- 7 passanger XJ?????
- How much lift
- Diff cover revisted
- Rear Coils
- Pics of my newly grooved Boggers
- Ho big is too Big.
- Info about years
- CarFax
- Faster Jeep
- swapping newer 4.0
- Group 4x4 Buys Web Site Address
- need new master cylinder.
- Rocker protection and Hi lift jacking...
- What bushing to use for LCA's
- Goodyear wrangler MT tires?
- New trac bar problems
- Front CV driveline on the rear?
- Rear Air Bags
- traction bar help
- Skyjacker lift
- Coil rear suspension again
- New 91 xj
- Moroso conversion is done!!!
- Low oil pressure warning system and oil pressure back up Q's
- rear tire carrier
- Can modifying suspension cause Over Heating
- tires?
- What length shocks should I get!
- Possible way to not use slipyoke?
- Not all 16.5" tires can be beadlocked?
- Caster and vibrations
- I Need Help!!!!!
- d30 U joint help!
- Stroker Info.
- Hydro boost instead of vacuume boost for brk syst.
- Lockers
- Spider gears/Carrier Question
- Ign. timing (was dist. indexing, too much cam)
- Leaking from rad. overflow port after rebuild
- drive line vibrations
- 91 D-shaft fit 99
- brake problem
- Gages
- Lock Rights
- lift kit
- control arm help plus free stuff
- waggy 44
- Cheapest way to make an ARB Lockup?
- Bridgestone tires?
- Lift/tire question
- Rear 1/4 panel wack
- Drivetrain Superstores?
- Rustys Long arm problem
- And the Baja Claws are in!
- micKey thompson tires
- New 8.8/ARB
- Used OME Suspension
- Shackle, Leaf Spring bolts seized in bushing?
- RE superflex joints quick q
- Adding MJ leaves to an xj pack
- Finally got some Moab pics scanned
- 8.8 Torque spec
- Motor Mounts
- still got brake prob
- No oil pressure on steep inclines
- lift kit
- Johnny Joint squeak
- RE 5.5" Long Arm or 4.5"
- Urethane bushing installation
- another OME ???
- Gear ratios and 4WD
- cooling (long)
- 2.5L temp sensor broke. Any ideas?
- 8.25 question
- Limited Slip Front Differential
- junkyard 44
- CJ rims
- wheel sizing
- tie rod building
- AA HD short shaft problem...
- Rubicon long arm kit?
- Welding Body Panels?
- Full leaf packs or add-a-leafs?
- cheap rock rails
- No-Slip install...FROM HELL!
- lmt slp to locker
- lift questions
- 2Dr rear fender trimming
- Geometry/math Q
- NutZerts
- TJM Tire carrier bumper opinions
- 35's on a 35
- lift
- Axle Tech
- width of xj axles vs. cj axles
- disc brakes on my d35
- Convert to manual hubs?
- How to measure lift - both front and rear?
- Backspacing
- Clocking the NP 242
- Engine Swap
- HELP - Fluid Leak Diagnosis
- lunch box locker in a d44
- Do your coils sit in center of upper isolator??
- air compressor conversion
- Crappy ride solution?
- Detroit lubricant opinions?
- Revolver Shackles
- Which Budget Lift?
- Borla Header-Cheap
- Going long x4
- Regear Cost?
- lift kit/ brake flaring help
- Oil filter relocation
- rockwell 2 1/2 ton axles in an xj!?!?
- Ox lockers?
- Neat trick for reindexing the Distributor.
- zig zag baby, zig zag
- LCA's
- power steering fluid leaks
- It's time to take it up a notch!
- 4.5'' & 33x10.50s- questions
- Up-Country 2.5L (Yes this is modified tech)
- Stroker Kit, does anybody know this one?
- Which LSD?
- Looking for steering solution
- Recommended CS Spacer
- 33/13.50x15 on 8" rims
- 15 x 8 - 4.5" backspacing - Do they exist?
- Replace clutches in factory LSD?
- LCA/UCA Lengths
- Some cooling questions and a little rant...
- ZJ shocks on XJ
- Track Bar and mount????
- full floater 8.8
- adjusting rear brakes on a d44
- '90 Xj
- Rustys tranfer skid
- can i fir 4.88's on an ARB locker on a chy 8.25?
- Battery going dead, Help
- Borla Header Q ?
- Steering box problems
- Diamond Plating on XJs??
- Rusty's shocks and Old Man EMUs
- engine swap prep work
- Removing Pitman Arm - Won't Budge??
- ARB airline ?
- Bridgestone Dueler A/T - any comments?
- Caster and vibrations
- Adapting extended SS brake lines.
- any good front 3 or 4 link designs
- wheel backspacing
- Replace 6" leaf pack, what brand?
- skyjacker 8" coils
- fog lights won't stay on
- Tire Pressure???
- ac and voltage drop?
- Anyone do the torque converter lock mod?
- Power Trax No Slip broke in 1/8th. of a mile.
- Death wobble at 55
- Coolant Bottle!!!
- CTM U-Joints
- tranny temp gauge
- upper CA axle bushing replacement
- Quality 4x4 shop in MD
- Fox Shox vs. Bilstein 7100's
- Winch not centered?
- Rear Tail Lights
- lift to fit 35"s
- High altitude CPS
- anyone with bedlined interior
- tire carrier/bumper
- wrangler D44??
- BPI Fab front bumper
- D35 to D44 or 8.25
- New steering Problem
- All this talk about inclined oil pressure has me thinkin'
- Best brake pads for WJ front calipers and caddy rear calipers??
- Cutting Trans output shaft
- Carrier bearings
- RE distributer?
- Clifford dual outlet header?
- Look what FedEx brought to me yesterday....
- RE Leaf Springs
- 3" BB questions
- TrXus - Rocks?
- Track bar limitting droop
- Those who are sporting 8" how low do you hang?
- Rear Tire carrier help!!
- Overheating!!
- My first chassis crack
- Shot Peening explained.
- studs attaching frame to floor. No Go, Help
- Flexplate Q
- relocating rear shackle mount???
- Hesitating XJ
- long arms
- how high to get 33's
- cable actuator?
- Getting new axles.. have some questions
- want to lift it WAY Up. whats good?
- Production roll cage!
- test
- vin #
- Brake Light Guards/Replacements
- UCA removal challenges
- Rear flex with Rusty's. Is this normal?
- Scared half to death!!
- front end lock out hubs
- TJ Flares
- motor mount bolts
- Bullet Proof vs. Durango bumpers/tire carrier
- ACOS (attn: Mark Hinkley)
- Estimated cost
- need pics of some in cab roll bars...
- Rubicon Stainless Header
- transfer case cracks,
- Motor mounts??????
- Front Leaf Bolts
- Wheeling a long bed MJ????
- Problems with lift install... looking for help
- which dana 44 ??
- any experiences with crawltech.com???
- Lift kit on the way need prep help
- driving without floor board
- To anyone with TrailReady bumpers
- Random sawzall fun
- Body mods for rockers and which welder?
- Poly Transmission Mount??
- Front winch bumper started and questions for fabricators
- Lock Out Hub conversion
- Axle Shafts from the Big Brother
- Building stroker...TPS modification question
- Straight tubing roll cage
- Rocker Rails
- Why the small rim?
vBulletin® v3.8.3, Copyright ©2000-2012, Jelsoft Enterprises Ltd.