View Full Version : Modified Tech Discussion
- 34 X 9.50 Swamper info
- Uh oh...
- Armor UP
- Check Engine Light
- Looking for Mounting ideas for 5# CO 2 tank
- WJ Brake Booster in a XJ?
- Theft protection
- another rookie question: shock travel?
- DD Locker Comparison
- Strengthening factory roof rails...
- Hella 500's on a stock bumper
- Upgrading 8.25....
- TJ rims with 31's on a stock XJ
- cb mounts
- 4wheel drive clunk...help
- Need opinons on steering setups...
- For those of you running the 9" rear axle
- Specific Gear Break In Question. Long way from the shop!
- Dana 44 diff cover fab..
- SYE kit install pictures
- 8.25 axles
- Pro-comp 3" lift LCA question...
- Did some wheeling, have a question (With pictures)
- Will NP231's Swap???
- 4.10?
- Calculating Milage
- want new steering system
- Manual to auto conversion
- bolt sizes and length
- humor for the day, critique my welds
- YJ slip yoke vs SYE help...
- ARB snorkel
- source for Heims, weld on tabs
- Lowest gearing available?
- IPF/Magic J's...where at?
- '98 4.0 w/100k miles, head gasket...
- Chrome Moly Question
- Extended LCA/UCA
- old 33x12.5 + stock rim = spare??
- SYE and now 8* shims?
- quick 9" question
- Towing questions???
- Gears and Carrier Question.
- how much do axles weigh.
- Kevins Track Bar Conversion?
- Rubicon rims & tires under a cherokee?
- 87 Dana 30 or 91 use which one?
- rs 5000's on 5" lift?
- Rear Bucket seats
- mounting the winch selenoid box questions
- diff -vs- tire size
- ABS sensor question
- angle of the dangle on t-cases
- Want to convert to the x297 series U Joints
- Help with brake problem, please...
- anyone here make custom tabs?
- CAD file for Frame brace?
- Brake line Replacement on a 5" lift
- Rear seat ideas
- Injector Needs ?
- 31x10.5x15" on stock rims?
- Driveshaft hitting exhaust downpipe
- How does aftermarket bumper weight impact suspension set ups/etc?
- 8.8
- rollcage padding
- Possible ignition wiring problem
- Towing with a lifted XJ
- Rant with a shock question
- Control Arm Info Please
- Longer Slip Yoke
- D44 disc options
- track bar question...
- What to buy with $100
- Rear bumper w/ light cages
- I just installed my Stillen rotors and now the Jeeps stuck... HELP!
- All you 9" people...
- jute padding
- Best way to join Johnny Joints to Radius Arms?
- Driving through water
- Tire size for mudding!
- Is there such a tool?
- I guess it was my turn for CA Failure...
- Dual Double Cardan Driveshaft
- A repair for caved in rockers
- Eaton E-Locker
- NV242 swap into NV231 XJ
- How much lift for 36's
- Back to stock...now I have vibes?
- Call for help!
- Newb
- 6.5 with no vibes !
- lift without compressors ? how
- Headliner
- Anyone ever "boat tailed" the front end?
- What Sye To Get Help !
- sound bar
- One simple question....
- front 60
- Measurements for a homebuilt frame brace
- My new MJ interior
- linex/hurculiner floors
- Leaf springs/ Revovlers?
- rear diff 87 wagoneer
- adjustable control arms?
- Shackle VS. Addaleaf
- truck bed coating
- Transfercase Options
- T-Case Drop / Skid
- Setting up HP 44 for coils
- i did a search on the forum......
- stupid shock question
- Novak shifter for the 231?
- How much spacing ..?
- bad vibes
- 4.5" BS and Goferit
- RE 1600 and HD mount
- ebay alt
- Options for uni-body repair...
- Maximum Milling of Block (Decking)
- Seat brackets for Mastercraft,Beards,Corbeau,etc!!
- Any advice on learning to weld.
- New Ebay Lift, This looks scary
- Avon Mud Terrain Radial Sxt ?
- Performance Exhaust
- AutoBarn, Mobil 1 Filters, buy one get one free...
- Cherokee flares
- '99 Control Arms in an '01?
- Making My Own Snorkle
- Relocating Shock Mounts
- Heims for Over Knuckle Steering
- axle swap question any size
- Stock tow hitch installation and Tomken gas skid
- Jeep AAL install + Few Tcase Questions
- Need a measurement
- Motor Mounts (bomb proof)
- revolver shackles
- 31's with 2 in. BB?
- MJ D44 pics?
- Dana 30 limited slip carrier
- Modifying for a BIGGER oil filter...
- '98XJ rear window dust deflector
- SEMA Consolidation of Lift Law Basics By State (Link)
- New RE control arm bushings?
- 33s for a ZJ, how much lift?
- Edelbrock aiir filter advice for upcoming project please!
- looking for an affordable lift
- oil filter mount mod
- install time on RE drop brackets?
- Shocks limiting droop?
- k&n filter maintainence sub...
- ABS frt or rear
- track bar length, does it matter?
- gussets for D30 and D35
- rear winch
- Ford Radius Arms
- Another gear opinion needed
- more rust
- Engine cut off while driving, possible issues?
- Rear spring install
- ARB tire inflation fitting question
- 3/4 Coil spacers
- will leaf springs "re-arch" themselves when unloaded??
- ARB solenoid fitting?
- wiring problems
- Anyone running the RE track bar brace?
- Rear Coil Springs Conversion
- PJ Dirt Grips?
- Rusty's 6 1/2" Rear Leaf Springs
- Drop brackets or long arm?
- build the 30? or spend $$$$ on the 44?
- Locker compatibility...
- XJ Front Driveshaft Lengths...
- Starting Problems
- ZJ Disc's on a 44 Rear
- 14 bolt & 10 Bolt conversion.... Need advice.
- 44 hubs
- unibody strengtheners/use what when?
- C02 Vs. Nitrogen gas
- whats the best way
- Pro Comp tire sale?
- best water pump for an 01 xj ?
- Brett's AW4 controler/shifter?
- could I get some help with choosing lift components?
- Up Country + Lift advice needed
- best deal on soft 8's/blk rockcrawlers
- Trackbar relocation mount
- transfer case swap or not?
- Right Hand Drive Cherokee
- Another XJ Hood Vent Install
- 2.5 blown:ford 302????
- archive of American Racing styles?
- got 6" but need 8"... advice
- Gas Tank Skid Prices
- d44 / 9" what years and makes
- Swapping in an 8.8 into a Comanche
- rubicon 44
- RE drop brackets price?
- Gears or TB Spacer?
- Blazer driveshaft question
- guy with rhino exterior
- Has anyone put stock front flares on the rear?
- Is the Dana 35 really weak?
- Axle Tube Seals
- Poly lift spacers?
- 2.8-3.4 4 Barrel ?
- LeBaron Hood Vents Installed!!!
- dyno type knowledge...
- New Ridigco rear bumper Pics
- super 35.... but at a good price
- 8.8/driveshaft...
- Rear Bumpstops
- rear 44/driveline angle
- will 1997 wrangler tj front suspention work
- My XJ took to the air today... need advice
- Iknowthis has been posted B-4 but...
- RE SuperRide LCA's
- Building a 96' XJ
- Adding a 12V outlet
- Identifying lift kit/shocks want better ride
- Question on which Front Coils to go with...?
- sidewall tear, anything i can do?
- Saw Zaw!
- MAX load weight inside the Jeep?
- HO Conversion Question (fuel system)
- idea- roof rail?
- Caster alignment-NEED HELP !
- Cooling the 350 in the XJ - questions.
- quick ford d44 front end question
- Help me build an XJ
- Help: Radius Arm's
- BO leafs- which boomerang?
- Rotating centersections...??
- which cherokee to build
- need some help with repairs and mods
- Tcase reseal
- Full Width Axles
- whos the gear expert?
- is this necessary?
- Lcokright to Spider gears
- LCA lenght?
- ring gear backlash?
- How hard to fit a pre-96 mopar gas skid to a 97+?
- Wiring swap
- Any one know the specific lengths of battery cables?
- swap RE for OME
- Help with an idea for 2" BB with AAL
- Upgrades, upgrades!!!
- rocklizard front bumpers on
- What should I do?
- Xj Lift
vBulletin® v3.8.3, Copyright ©2000-2012, Jelsoft Enterprises Ltd.