View Full Version : Modified Tech Discussion
- RE pivot shackles
- Before you ask a gearing question - look here
- Track bar conundrum
- homemade drop bracket braces
- soundbar instalation?
- Rear axle bracket set up
- RE Gen II discos
- best way to recover a flopped or rolled XJ?
- Why A Cage (internal)
- overhead console install
- best 3.5"-4.5" lift kit.
- Wobble after bump?
- 78 wagoneer D44 donor
- Another budget lift in progress!
- Track Bar Bolt Waller
- XJ Fuel Safe, or Fuel Cell
- worth the 44?
- CJ Flares on an XJ?
- Too good to be true?
- electrical accessorie question
- Factory Tire Carrier & Hi-Lift?
- rustys 9" coils
- RE super flex or RE super ride
- Brake Upgrade
- Rubicon Express Monotube Shocks?
- front end rebuild kit ??
- removable doors
- '98 neutral safety switch location...
- Bilstein 5150
- PLEASE tell me how I screwed up buying these axles?
- Steering Parts
- Magnum winch
- Exhaust Downpipe
- RE Superflex joints
- extreme XJ finished
- lift Q's
- Door mod question
- tie rod flip.
- 6 inches w/ no SYE?
- Nice Videos of XJs doing the JeepSpeed thing!!!!
- Noob w/ some 4.3 swap questions
- '97-'01 XJ Cargo Cover?
- Heat shielding
- Front leaf spring x-member pics
- Brake master cylinder questions.
- 4.0l Question!!!!!!!!!!
- Best transfercase yet.
- 231 spline count
- Heater Core install Writeup?
- Ideas about leveling out
- Casablanca Headlight Conversion
- coolant temp sender
- lift question
- front end woows
- After market steering wheel swap ???s
- Couple Ford rear axle questions
- RE lift question
- Please Help!!!
- How dangerous to make a 4dr topless?
- Another Stupid Question on Gearing!
- Dana 30
- RE Hack n Tap Tap size
- Fuse size on Cobra CB
- It will fit right?
- Custom FIPK write up...
- any advice? (a little lengthy sorry)
- anyone running the uniball joints
- 231 Output Shaft
- Class III Receiver Hitch (Suggestions?)
- Ox locker cable movement?
- death wobble
- Taurus Fan Install
- backspacing question
- What is BS?
- Full width XJ 1st flex pics
- Skid Plates.
- Headlight loom troubles
- Which rock rails....
- Bushwacker Flares on a 2001??
- Mr. Alternator
- Problems starting the new wagoneer limited.
- Upcoming NP231 Advance Adapters SYE Install
- Coax routing, and FireRing question
- ZJ Steering
- full traction components
- vibrations but not driveshaft related
- Dino or Synth in a new engine (stroker)
- Need an arb fitting FAST!
- Heavy duty bumpers vs tow ratings?
- SYE bearing
- XJ control arm drop brackets worth the money?
- 1980 F150 2WD 9" - Good Swap?
- home brewed winch bumper questions
- rear disk brake
- Remounting axle end CA mounts
- ignition ciruit
- Crager Soft 8's
- Am I at the limit of my ignition?
- strange clunk, suspension questions- out of ideas
- d35 non C-clip strength
- Custom LCA Q's
- getting ready to put on my Rustys lift
- would like 6 not 4 :) what do i need?
- My info. center said "emiss Maint", what?
- Found: 78 Ford F150 Ranger - Runs
- does this look like 3"s
- 4.0 nonHO hoses on a 280k motor
- Need axle opinions
- ideas;rear coil-conversion '?' question.
- bumper mounting options
- Can you help this lady?
- Brake Upgrade Needed 94XJ
- homemade drop brackets?
- tire carrier hinge
- measurments
- 6" Full Traction LA install help
- 8.25 spool???
- Pro Comp leaf spring packs
- MJ lift question
- Substitute for expandable foam
- can you:instal two add-a-leafs?
- New rear shocks size?
- T-case e-brake?
- Front DS in Rear
- Anybody ever done this?
- removing carpet.......
- Bumper Drawings???
- Weird noises
- Requesting New Opinions on Shocks (comparing a few brands)
- High clearance shock mounts+OME shocks ???
- posting pictures--I tried the search
- Spark plug?
- Tire opinion
- What does everyone think of this antenna mount?
- Radiators
- d44 u-joint ideas
- ZJ Pitman Arm
- Info on Trailmaster lift?
- confirming alternator upgrade pre 91'
- C-clip Welding?
- Suggestions?
- Need Waggy 44 axle width help
- Need a diet
- Atlas & AW4
- Shortening a driveshaft?
- CV shaft shim question
- to weld or not to weld
- Atlas questions
- Hello from Haiti
- shock selection
- Anyone using these tow hooks?
- Dana 300 Install?
- carborated I6 header?
- after a few weeks of research, my brain is fried!
- Looking at 3 Different Tires Opinions Please
- 3.75'' Backspacing on stock or trimmed fenders (no Bushwackers)
- Headers, muffler, ect
- Glow gauge faces flickering & very warm!
- What axles to look for in salvage yard?
- Scout D44s
- sleeving the tie rod
- Exocage
- CSF thread size
- Lift Disaster
- altenator relocaton bracket
- Drilling the Track Bar Mount
- 88 XJ specs
- Changing dashboard gauges....can it be done??
- small bearing chevy spindle source
- Wheel difference
- Installed the Locker, now what should I check for?
- MJ dove tail started
- Tera 2 low mod.
- inline fuel check valve
- 2 door rear windows
- Avoiding lift disaster
- Double Cardan Joint replacement
- Found axles out of a 78 F-150!
- Cross member design?
- Rear driveshaft question
- Custom or home brew gas tank
- From 3 to 4
- What did you pay for your HP44
- RE 5.5 kit
- soft shocks
- torque specs
- weight of dana 44
- dana id question
- Locker Question
- Tire, Rims and back spacing
- 76/77 F-100 9" questions?
- use waggy 6 lug outers on dana 30?
- tie rod flip
- Locker/Gear Planning Critique
- Suspention Upgrade Confusion!!??
- tire mounting question
- Which Shocks To Get??
- will i need a sye or new dshaft?
- what tire is better
- Using factory switches
- 3.5" RE lift for a Utah guy?
- Should I get new LCA's for a 3" lift?
- Renix HO project ? - Idle Air Stepper
- How bad is this??
- Rubicon springs
- D44 axle u-joint dilemma. Rebuild my used CTMs, or buy new Longfields???
- Tranny stress from gears?
- Stupid muffler question
- D35-8.25 swap, Driveshaft length?
- Rear Opyions For Lift W/ Front Susp Still Up In Th Air
- front and rear D60's?
- help installing a lockright in a d35...
- biggest tire for a 8.8
- Rear Traction bars
- Where to get a diagnostic code reader--How much and where???
- transfer case in a durango?
- Pic Request, BDS 3" Full Packs
- Jam nuts on LCA's
- Best Price For A Warn XD9000
- 4.0 HO Intake Manifold Conversion
- Ford 9"
- tires ...i know...
- Balance tires with ceramic beads?
- Inner axle seal for 297 axle swap
- Fabricated front bumpers.
- Pontiac V-8
- Remote progressive door unlock...
- Roof Racks
- Powertrax Install
- SYE and DS Installed - Pics
- Laptop mounting.
- Shim question without SYE
- Can a stock 231 t-case survive behind a 4:1 Klune V with stock AW4/4.0L in a XJ?
- 10 inch rims and backspacing
- ORGS shock mounts
- Heater Fan Question
- Another Locker Question
- Wiring Full Size XJ Gear Tail Light boxes
- In the middle of lock rite install, PLEASE HELP
- Rear Main Leaf opinions
- tcases
- atlas pricing
- loud scratching noise from tranny
- Start From Scratch; What Would You Do/not Do??
- help with lowering transfer case.
- Are drum brake explorer 8.8's 31 spline?
- ford motorsport disk kit - anyone installed one?
- electric fans
- Question about DIY Alignment
- 22yo first rig, need help.
vBulletin® v3.8.3, Copyright ©2000-2012, Jelsoft Enterprises Ltd.