- D60 front
- Who's the best High Steer Arm Mfgr. ??
- reccommedations for addons to my lift
- Northstar 32v swap
- a little help please
- D35 Failure
- spare tire mounting options on an 85 roof
- Relay Question
- ARB Snorkel
- New to me XJ
- Got a Chopped XJ?
- Front hub conversion
- rookie gear pattern
- need help
- track bar ball joint noise, help!
- kingpin?
- 97 Fender flares
- driveline questions
- D44's front and rear
- adjustable control arms
- Articulation with minimal lift
- LUVMYJP: I finally got some 8" rims
- Cheromanche under way!
- Rebuilding RE SuperFlex Joints
- Any suggeation on speaker locations for MJ
- Dana 41?
- another front end noise thread
- Jes, Other OX guys...
- 8.8 Ford Need Ratio
- new LCA's ?
- Speedometer cable ! help
- pitman(?) arm
- something between d44/d60
- Brake line ??
- 231 t case swap ?
- Rear Traction Bar Idea
- 260 to 297??
- What lift??
- Long arm conversion
- Help me decide
- PSI for driving on snowy/icy roads
- Rear seat Hi-lift mounts...
- 4WD Shop in Nashville
- need help with axle swap
- Locking rear
- JKS control arms
- Control arm axle mounts
- Hp 44 Ball Joint Vs. Hp 44 Kingpin
- best differential for winter weather
- new engine running rough
- Engine/Tranny skids - Preference?
- Question RE Lockright / EZ-Locker operation
- trac bar bracket
- xj swerves w/ gas
- Axle shimms?
- spare tire carrier for rear receiver
- Just picked up some 30x9.5's
- Place other than a dealership to get a speedo gear?
- Quick Disconnects
- I HATE plastic!!!
- RE1345 ZJ spring question
- Rear Lockers
- Life Span Of A U Joint
- Drag Link
- Strange Lift Pic Request
- speedometer
- rear upper shock mounts, moved up?
- How to lose an inch on my RE 4.5 ZJ coils?
- lift???'s
- 8.8 width
- extended slip yoke
- Axle wrap ? ? ?
- intake question
- Will a '92 AW4 work in an '89?
- 8.8 parking brake issues
- 8.25 4.10 gears and 10"brakes
- small lift steering upgrade
- zj rear disc question
- long arm and lift question
- Mickey Thompson Baja Radial MTZ
- OBA Systems
- np242 6" lift
- NP242 swap
- Winches
- is a right side xj snorkel available?
- Teflon
- Electrical Question
- i need 297 swap guru's ASAP
- custom battery cables...
- Need help from any Jeepforum.com member asap
- Rubicon Manuf. Shocks
- Shackles????
- Drop Brackets Hitting Chunk
- motor mount broke ! help
- Need carpet
- Would these help my winch bumper
- how much lift for 40s?
- Stock axle (D30/8.25") Tire Size Compatibility...
- forever for jeep to start. help !
- are DB hard to install ?
- exhaust options for '01
- New to Jeeps
- good tires for offroading
- Pernelli Jones Dirt Grips or Iroks?
- 7.75" Drop shackles, Hole to Hole
- Lift Kit Options
- RE Gen2 Discos
- What tires for my needs?
- Install question...
- Move over
- Poly Bushing on leaf melted
- torque converter lock up
- Clayton Long Arm Kit
- rancho coilovers
- Engine block heater
- GM bolt pattern on AW4
- Help. Radiator drain plug came out.
- best free mods
- Alternator Swap for Pre 91 XJ's?
- Who makes the BEST gas tank skid?
- ride quality
- Looking for manual for plasma cutter
- 2dr xj cut out help...
- Lights Diming??
- Should I buy this kit?
- 4.5" lift with fixed lcas
- stuck lug nut
- ebrake cable clamp question?
- Adding some more lift
- A different front end question...
- Tomken Susp. ?
- 351 windsor swap
- can a 92HOcam beinstallied in a884.0????
- big bang from rear?
- Drive shaft vibes (front vs. rear)
- Replacing Coil Springs
- Placed An Order
- How many have actually broken a Super 35
- 2wd trouble after t-case drop
- Rusty's 4.5 lift
- 8.25 or 4.10's?
- Grinding Noise from T-Case? Front?
- Tow hooks
- short to long arm conversion?
- 97+ XJ Seats in a 89 XJ 2-door
- 33x9.5's
- waggy 44
- Anyone else make a H&T besides RE?
- Building Bumper Brackets
- Q: about control arms
- 4.88s for D30
- 31's without lift - How bad will they rub?
- Anyone run RE3.5" without vibes
- 2.5L backfires?!?
- Poly bushings all around: yes or no?
- RE 5.5" - What shocks are you running?
- Driveshaft Angles - Blocks, Shackles & AALs
- jb conv super short slip yoke elim question
- Dynomax warranty
- d&c extreme rolcage help pleas
- Getting ready to lift...
- seaking 4.0/4.2 stroker web site
- Most Useful Air Tools
- Bushwacker trimming
- Add-a-Leaf or Full Leaf Conversion
- I blew it up...
- re 6200 install woes
- Saggy rear end
- piaa 520's please help.
- Front Diff Guard Help
- brake question (non-tech)
- full widths in the area?
- ARB Snorkel Install
- sway bar necessary????
- 04 f350 rear end
- Best Paint?
- Remonving 9" shafts?
- AN fittings and brake line? Beezil...
- trans swap=ticking noise
- zany trac bar idea and q's!
- How much lift needs new control arms?
- snorkel
- 8.25 upgrade??
- Tie Rod Ends
- 8.25 gear ID
- Header part number?
- 8.8 question
- New Carb Needed (only $250 to work with...)
- Best Rear leaves for 8" Whatcha running??
- simple question
- D30 Knuckles
- Ball joint Help!
- 2.8->3.4 swap...DONE(kinda)
- Rocklogic control arm sleeves!
- What To Do About My Axles
- Looking for 8.8 brake help (not e-brake)
- D30 aluminum seals
- Rear bumper suggestions
- HO to renix TPS-Tranny shifting
- How much lift for 265/75/16s on 99 XJ
- ? on xj coil springs
- Bigger Brake Booster Question (?)
- 2001 XJ engine mod's? help...
- 2001 Xj-help With Engine Mods!
- windshield breaks
- pulls to the right
- another lift question...
- Lift Q's
- Finally got a cage
- making a skid/questions
- no sway bars?
- External Trans cooler
- Winch and mount for my cherokee????
- Project 33
- To change the tranny fluid or not to change the tranny fluid...
- Tubing Benders?
- Front End Vibration
- Recomend me a track bar!!
- AW4-vent or vacuum line?
- Been searching since this morning - factory winch option?
- New ignition
- New guy here Arizona, my XJ!
- Equalize new rear springs?
- Hello I need again your help my friends
- Quiet Catback Systems?
- did i ruin this new johnny joint?
- IPF 968's
- Which Winch?
- NP231 rebuild question
- No-Slip not engaging
- Bigger battery cables??
- Looking for interior image/schematic
- dome light "upgrade"
- HD SYE installed, now 4wd light won't go away and vibes with 8.8
- Fender Cutting Help W/ Pictures
- 95 ford D60 usable?
- 3.8:1 Atles
- hydraulic brake assist
- D35...what should I do?
- Tubing size for suspension link?
- Drop Brackets & Skid Plate
- fabricator wannabe
- Worth it to go pass side drop?
- hack n tap
- what do you think about this price?
- Overheating and no interior heat?
- steering box brace with hydro assist
- Pinion Seal
- Already have 3", I think. How to add another 1"
- 8.25 shafts 27 vs 29