View Full Version : Modified Tech Discussion
- Installing Tomken tow hook brackets
- Consequences of tuning - emissions
- Cutting Drive Shaft
- essentially off road cage
- Brand new OME lift - Uneven in rear
- putting gears in a 8.8
- pinnion angle shims?
- Rusted out Rocker panels
- Small lift questions
- mounting lights on the roof w/o roof rack
- cheap warn m8000?
- RE front axle bracket kit...who's done it?
- can a track bar be cut and lengthened
- Engine is dying........
- stainless swaybar disconnects
- D44 Disc brakes on a 8.25...Can it be done?
- Uh, tweaked unibody
- Bushwacker vs TJ flare size
- Winch grease
- Hot (to the touch) Hubs
- Brake Line Info
- LCA's(NewB Q)
- wrangler np231
- Rusty's leaf packs?
- Mile Marker hub convertion
- gear question
- d30 posi-lok issues!
- RE Drop Bracket Braces
- Building a Rear Spring Pack
- Call for Picts
- Fender flares
- locker selection front(aussie locker)
- Wheels for the Ford....
- PS pump problem/question
- Taper/size for 1 ton TREs
- Power steering cooler for 10.00 and 1hr work
- what cam to run
- Is it possible to increase my tow capacity?
- Which winch bumper?
- Installing C-Rok Help Its Dark
- Terra-low Best Price Any One???
- old bronco d44 and 9" how hard to swap
- ipf harness question
- Another crappy what should i buy thread
- Front bump stops
- stupid u-bolt question
- experience with posi-lok??
- what to expect from rustys 3.5" add a leaf
- Which black steelies?
- Bolt size for RE drop brackets???
- spray gun. where to buy paint?
- XJ setup (tires, suspension, brakes)
- TJ 44 Shafts
- Regearing 32's??
- Banks Head Pipe for XJ??
- Any real advantage to a true dual exhaust?
- Upgrading the Intake Manifold on my 91
- best unibody beef up
- Rear Tire Carrier
- Lift Kits
- tire sizing
- Custom crankshafts?
- remote starter...
- E-locker
- Rubi Wheels...
- mj soa help needed(please)
- Calling all guys that are running OX lockers.
- POOR old MJ *** Sensor I think HELP PLease***
- Toyota guys....Pinion length
- Question about TPS
- Locker with NP242
- mj soa
- Speedometer and AW4
- difference in lighting
- Does Anybody Know If...
- full width axles
- can somebody identify this rack?
- Fabbed bumper fixings
- 30" tires on 3-4" lift...pic request.
- Lots of Trimming with Stock '97+ Flares
- Will a ZJ or KJ overhead console fit a XJ?
- mounting shocks to control arms
- 1979 Ford dana 44 bronco
- Coil Spring Compressor...should I?
- Metal Replacement?
- Will a factory gas tank skid from a 96 and older fit a 97 and newer?
- Permanent way to remount factory flares
- Cheap xj mods
- RE Upper LCA's and...
- what to do???
- bulletproof company change
- GearS for my B DAY!
- HELP!!! I need to get the carrier out of my Dana 44
- Leaf springs
- where could I buy RE´s Kits for a good price?
- I want to see the best Cherokee XJ pictures
- ford 8.8 ?
- D-44 / Ford 8.8 and 96newer Anti-lock brakes
- Rust Free Steel
- cj steering knuckle on stock 30 has anyone tried this?
- Ditching the Pro Comp?
- spring mod suggestions?
- ARB or CO2 to fill tires
- Limiting Straps and center limiting straps
- tranny cooler question
- 31's on a budget boost
- doing swap ,need info,PLEASE REPLY!!
- Where do you guys get your cps, tps?
- Installing a cooler
- Best source vehicle for HP44
- BFG M/Ts or GY MTRs??? 33x12.50 flavor...
- IPF 630 amber lens question
- What are you runnin?
- What lift for stock control arms?
- Need help finding noise
- Best TUBE Rock Rails?? Pics?
- What are some good performance mods?
- RE 4.5" lift spring and shackle question.
- chromo shafts and ox joints
- '98 brake booster and m/c on a '90
- who's running 14" travel shocks up front? specifically Bilstein 5100s?
- New snorkel write up
- Ipf J-01
- I found a great page with great prices in RE. what do you think?
- rear bump stops
- 85 8.8 axle specs...?
- tire on conferr
- New shock bolts and what else will I need/should I have?
- Oil Problems with the 4.0
- tranny mounts
- can I jack up one side at a time to replace rear leafs
- front and rear bumpers?
- Best dash-mount GPS system
- Hub and Rotor Clearence
- BackLash?
- How hard would it be to swap in D44's?
- Help settle an argument...PLEASE
- Loud Pop/Extreme Bogging when turning
- Gibson Exhaust
- C-Rok Fab
- dana 35c
- XJ into a pickup
- rear Detroit, 1st impressions...
- How can I get more shock travel in rear?
- Brake Rotor Question
- trail rig build
- np205
- clayton: 1 upper?
- Nth Degree Mobility
- Speed Sensor for Chevy EFI
- which tires?
- Carb'ed vs. FI cams and cam selection question
- WJ tie rod to tie rod length?
- SYE and 6.5" lift
- rear xj 44 yolk/ubolt ques.
- stoopid D30 ???
- have a problem
- budget lifts
- going to buy a lift
- what would cause this?
- Nth Degree OPS Installed(write-up)
- RE 3.5, SYE and Kevinz Sliderz write up - long!
- Control arm reattachment after DBs???
- Bronco Progressive Coils
- driveshaft problems HELP PLEASE
- Suggestions on running 38" or bigger...
- Interior Cage How Much?
- high-steer "kits"?
- NP321HD question
- Dand C or essentially cage?
- Stock headlights to H4 replacements?
- Disconnect Pins
- Help with gears
- Finally, time to order my RE lift.
- A 94 2wd draglink on my 99 4wd
- Spacers?
- Wich shocks for 6,5" with longarm in front and coils in rear
- Heat Sheilds
- Spare Tire/Gas can receiver mounting
- Would like input on motor mounts
- NP203/NP205 Doubler adapter....
- A hole in the firewall?
- NP242 rear output shaft
- lift question
- Largest spare in factory location 97+
- borla header and o2 sensor
- Trimed fenders
- Installing Shackles
- Full Traction 6" Lift
- RE SS Brake Line Question???
- Axle compatability
- Auxillary gauge choices...
- OME shocks
- Trackbar relocation advice needed...
- optima battery question
- 4.88 in Chrysler 8.25
- tire question for a buddy of mine....
- Going from 4" lift to 5.5" ???
- why does my XJ drag to the left?
- 4.5 inches and 33s
- Double Cardan coversion question
- TrXuS MT?
- need answer on loud noise Getting ticked off
- new tires in the spring
- Safari Snorkel Install....
- OME Shocks part #s
- full front windows?
- Looking for 760 joint with needle fittings in caps?
- 37's + 4.56 = ???
- Another Cage Thread (pictures)
- Easy solution to 35” tire vibrating and rattling on back Custom 4X4 bumper.
- XJ width?
- What else could it be
- Warrior brand quick disconnects and bar pin eliminators?
- cps question??? help
- Mickey Thompson Baja Claw radials
- Hydro Steering?
- Axle Seal
- Tailshaft Bushing Replacement
- High Mileage 8.25 help
- tj flares
- Wanna lift another 2"
- TJ D35 on my XJ?
- ebrake
- Toyo Open Country M/T's
- Rusty's 3" Lift Help
- will i need shims and new bumpstops?
- HOW to adjust Adjustable control arms
- Old Man Emu leaf bushing question...
- dana 44?
- Best Rock Rails For Moderate Off-Road Adventures
- Granada 9"
- Rustys Lift Kit
- What do I need for 4.56 gears?
- After market rotors
- Seats
- Custom Bumper Project: Dos and Don'ts -- DO NOT HESITATE TO POST
- YJ Fender Flares???
- engine running cool, from hoodspacers?
- Hesco C.S.
- Name that noise?
- Whats to stop me from using this winch?
- R.E. Track Bars
- steering stop broke off, what should i do? tried drilling...
- OEM Jeep parts online by part #?
- building control arms
- 33x10.5" front and 33x12.5" rear?
- Engine Preoiler and Accumulator
- YJ brake lines on XJ
- I want 1.5" more in my 5.5" RE kit
vBulletin® v3.8.3, Copyright ©2000-2012, Jelsoft Enterprises Ltd.