View Full Version : Modified Tech Discussion
- Super Swamper LTB
- Taillight wiring issues
- NP242 w/SYE problem ... any ideas ?
- Currie Steering owners?
- hub question..
- I never want a tranny problem again
- towhook bracket bolt
- extra stress of lift and tires?
- Don't understand this rear-end gearing/swap thing
- Cage Guys: How does it affect steering?
- Good deal on Mike Leach header?
- Question on metals
- Should I go with the 8.25 or Dana 44?
- TJ coils on XJ
- steering box brace
- 8.8 swap and E-brake cables....what to use?
- FYI BFG Krawlers CHEAP!
- ideal gear ratio for 35in tires ?
- Tranny Cooler
- AC compressor / bizzare idling issues
- Extra vacuum lines, custom air tube
- np242 specific lift questions
- door panels
- Mark U joints before taking them apart?
- body herculiner/durabak
- Alignment Specs for 4-4.5 inches
- 97+ Removeable Doors
- Home-brewed Long Arm Kit UCA
- Slapped on the bumpers finally
- Radiator conversion done
- D30 steering....again-sorry
- zj booster?
- 97 4.0 to 99 Block Swap
- 2.5L manual -> automatic tranny swap
- I know, I know...another hood vent thread
- Roll cage in my XJ is done with pics...
- Need a Front Bumper...
- H.O. heads on my stock, renix block
- Lockers, difficulty level????
- turn limit adjusters??
- 8.25 skid plate/rock guard..
- ARB Experts- Please help
- Re Bb
- Flowmaster 4o Series
- Ya wanna check my pattern real quick
- Suspension Tuning
- ZJ Proportioning Valve in a non-ABS Brake System
- 4WD STILL not engaging correctly GRRRRR
- Add-a-leaf to lifted springs
- steering stabilizer
- Rusty's, RockKrawler or RE?
- Chevy TRE taper same as Ford TRE taper??
- best place for gears ?
- Roll cage welding?
- Shaving 8.25?
- Drive line for a SYE conversion
- A/A SYE problem
- Add to a existing lift
- TRE part# for flip?
- OK . . . flame my sorry butt . . .
- Yes officer, my bumpers ARE legal....
- front window conversion
- Front axle bracket locations.....how are you guys jigging them up?
- Supporting Vehicle weight on shock mount
- Your Thoughts
- Rear Towhooks
- Searched First: Long Arm Discussion
- Building Long arms, have a question
- Winch mount
- replacing injectors got a question?
- AW4 Shifting Problem...
- Baby swampers
- wide 33s vs 35s
- SSR swamp tsl radials
- Axle options
- Driveshaft Rumble?
- Cheapest Price on SYE
- Anyone using Rusty's flares?
- Long Arm Build Q.
- Internal Cage Plus Overhead Console
- Sliders
- 2.8 to 3.4 stroker ?
- No One offers an SYE for an NP 242?
- Does ANYONE make a decent 2" aftermarket flare?
- suicide rear doors
- Front end looks off center after lift!!
- 242 h&t and TW install - thanks to all
- New bumpers and rock sliders are on...
- 33s on stock wheels?
- what kind of wheeling for WJ knuckles?
- Build up using all Jeep parts?
- steering/handling question
- door removal
- spray paint
- 15x8
- Front Brake Rotor ?
- air intake question
- Ready to order lift.... is this OK?
- wrecked xj
- converting a '96 ZJ booster and MC and prop valve.
- Flexed the 3 link today, pics.
- 2" or 3" lift on a 96' XJ
- NP242 Alternatives
- Cracks, cracks, cracks....
- Rusty's 4.5 lift for everyday?
- DIesel conversion (anyone done it yet)
- Rusty's X-member with Tcase drop
- Good After Market Rear Bumper??
- Tera Low , Good... Bad... ????????
- Inverted Y OTK?
- Trimming stock flares
- clayton x memeber and RE long arms
- Going to 4.5"..
- lca with cracked bushing
- "Uflipping" a d300
- 2000 XJ Brake Booster
- drag link /tie rod
- ID on Rims/Wheels...
- 3" Lift and shocks..Help !!
- Need 2 more inches from my RE 3.5" Leaf pack
- driveshaft length??
- Who here Herculined front or rear bumpers
- Skyjacker 8" Rear Leaf Springs
- Death wobble
- Pinz thread removed?
- Cheromanche
- Fire damage?
- Gears are in, but axle's a bit leaky...
- Another lift question
- SS rear disc brake lines?
- u-joint upgrading, but only a little
- Need help with Rust'y 3" w/add a leaf install
- Dana 60 swap mount question.
- Full Width Advice
- why are my arms and springs popping?
- Bumper Brackets
- MSD-6470 ?'s
- Distributor setup
- Quick Question about lockout hubs
- Yj Steering
- Tire Inner-Tube
- Locker Q
- "normal" AW4 temperture
- Pulling Carrier for Locker
- Auto trans tech for the geeky engineer types (like me)
- need help with rear bumper
- Spring geometry (noob question)
- Lift in inches to clear 37's???
- Downfalls of Swing away tire carriers
- Solid floor on roof rack?
- Doing my lift tomorrow . . .
- RE 4.5" Rear install Questions.
- 4.5" Lift + Bushwackers = What size tires??
- AX-15 Issues...
- Moving the Trac Bar
- Crawl Ratio's...
- LCA lenght and design
- Where to buy OME?
- ARB Bull Bar Warranty?
- HP D30 Pinion/Castor angle using diff cover as the reference.
- Auto Tranny in a 2000
- many questions
- poor boy lift for 86xj
- Reese on the front bumper
- Looking for MJ flares
- lift problems????
- Bored TB Question
- Put a '88 I-6 not HO block into '92 HO?
- need instructions for installing factory gas tank skid plate on 90 xj
- Track bar help
- need instructions for installing factory transfer case skid plate
- which bolts for differential skid plates for 90 xj
- Mean Green Starter not working.
- BF Goodrich MT's
- Exhaust?
- Did the Torque Conv. Mod. Ques?
- backspacing questions
- Rubbing...
- transfer case noise
- 2WD to 4WD swap?
- Steering Box Q's
- 1998 XJ trans low/2nd gear & TC lock-up?
- did yours settle ?
- Fender liners and Grease
- loss of gas mileage
- Doing the Budget Boost
- Dana 44 questions
- waggy steering
- Prepairing for Stroker???'s
- Rolled my XJ today...and I couldn't be happier
- Front drive shaft
- Anyone used a bender like this??
- herculiner on plastic?
- Junkyard 6" leaf pack
- rim size, with tires
- extended bumpstops?
- Looking for a Trann cooler
- Show me the PICS!!
- Redline Water Wetter
- Brake upgrade for 4-wheel disc
- Help with a big Project!
- Hanson Bumper
- YJ brake lines
- ARB bull bar with c-roc's steering box plates?
- multiple blocks
- Going full hydro steering
- Front Bumper is comin along.
- rear gear oil pushed out
- 3 inch blocks????
- Budget Boost Question
- One More Frt DS ??
- Mopar Perfomance Head Gaskets
- Hit a ditch, now frt end wobbles
- 5.5 " Lift
- Ditching Peugot for AW4 Auto, Need Help!
- Rubbers.
- How do you tell if a ball joint is bad?
- Keep the Posi or weld it.
- best exhaust for the dd
- front 44 upper arm mounts?
- XJ coil spring bow...help please
- t-case rebuild kit?
- FULL FACE front bumper that replaces entire nose??
- D44 pinion vs. 8.25 pinion
- MJ rear SOA?
- Turd Polishing
- people with a stereo system, help
- 99+ intake conversion vs. cold-air vs. snorkel-air
- Sleeving the frame rails
- alignment.
- Plug wire opinions
- Best price for long arm kit
- EZ Locker
- ?s D44 vs. 60 dilema
- tera flex or tsm rear disc?
- The low-down on RE spring rates.
- Lets get down to it. (Diffs)
- Front 4 Link Finished & Tested
- anyone have the Olympic Tire carrier?
- will a front DS work with the hack N tap?
- front axle pinion angle
- All this weight of bumpers, rock rails, rocker panels vs lift kit
- Where to get Distributor Cap and Rotor?
- Drag link and disco issue.
- Bumpsteer???
- To lift or not to lift
- lockout hubs
- Locker questions
- Anyone have experience with Kumho Venture MT's?
- Anyone used or heard of this bedliner?
vBulletin® v3.8.3, Copyright ©2000-2012, Jelsoft Enterprises Ltd.