View Full Version : Modified Tech Discussion
- Where to find D-Ring shackles in black?
- D30 Detroit install (question about clip on axle)
- XJ D44 swap into MJ
- Re6025
- EB D44/9" Swap Questions
- Powder coat or paint
- bearings right or wrong?
- u-joint size
- Gear Setup
- High pinion D30 vs. low
- Rear Bumper.... DONE!
- Speakers too heavy for back hatch
- Can I turn the DS Tie Rod End to top of knuckle?
- 360 cid transplant to an XJ
- Tubing bender question
- Did He say Hiem Joint Linkage?
- Looking for opinions on RockKrawlers updated long arms
- Is anybody here from Michigan?
- RE adj LCA's
- Let's play the Ford axle identification game.
- 86 XJ Mopar 318 Engine Swap
- which winch to buy???
- Rhinoline, herculine? Who is happy with the interior w/o carpet?
- Wheels, Backspacing and 31" BFG's
- XJ gear Ratio ????
- Detroit EZ locker
- Front Dana 44 info
- Rock Rails
- 32s are on!
- Suspension up travel, shocks, lift
- Are TJ and YJ rear flares the same?
- Shocks, wheels, tires
- Where to mount the spare
- 4" going to 5" - UCA's??
- adding receiver to c4x4 front bumper
- metric equivalent of 11.5" tire width
- Crazy Idea? Portal Axles.....
- XJ 31's and 4.56 gears?
- stroker motor
- Tube doors' cage
- looky what I just finished...
- Front 44 Trivia Time
- Yet another gear question
- Anyone interested in a write-up on Warn FF install?
- XJ body on frame question
- Best place to buy McGard lug nuts
- Over the knuckle steering upgrade ?'s
- CO2 4 OBA (already searched)
- Anyone hard line there OBA lines?
- Dana 44 Option, Can it be Done???
- Attn. URF Manufacturing
- Some real advise
- Quick question
- Lift, axle swaps and other mods started
- does any one have this set up
- Add detroit Abs light on
- Torque Converter Relay
- Help with RE 5.5 Short arm lift please
- Which speedo gear?
- Long arm question
- My new tailgate
- Road Trip
- question about a nut???
- Gear Pattern Question
- Definitions please......
- pivot perches
- 92HO in 89 XJ
- Tire pics/opinions needed
- DANA 44 DISCO vs DANA 30 NON DISCO
- Free Carfax....today
- 10 bolt question
- xj belly skid??
- MJ gas tank skid?
- stock arm length
- back at it with the exo build
- lets see you home brew bumpers!!
- bought a drivers side pinion front d60 cheaper to retube axle or put in dif t-case?
- On Stock Axle Shafts, any advise for best u-joints?
- 98: removing airbags
- Ford RC HP60
- suspension change (short to long arm)
- Plugs.... plugs... plugs
- Deeper than 5.13 for 14 Bolt
- driveshaft goes clunk
- Bumper Mounts
- 1'' coil pads & 1'' lift blocks, control arms?
- Best place to buy gears?
- progress pics
- hi steer ?
- Will these chevy shackles work?
- Caster and u-joint vibration
- front shock mounts
- Trying this
- jks disconnects
- 2" lift question
- SuperNerf problems...
- quick cage/roof rack ?
- 71 ford hp44 upgrades.
- New gauges
- crazy hydraulic longarm idea
- Switching from vacuum axle to non vacuum axle?
- fun with poster board. 4-link mock-up
- My front bumper
- 8.25 adjuster tool- build it for $5
- Wiper fluid coming out when at angles
- another long arm ?
- Ramsey winch problem
- Best place to buy a Modine 2-row Radiator?
- Different brake swap question
- Axle swap questions.
- 8.25
- Whos happy with their Redneck Ram???
- Stock shocks - poor ride
- Which E-brake Cables?
- winch paint opinions
- help wiring extra dome/cabin lights....
- D30 LP question
- D30 shaft question
- LCA bushing sleaves....
- belt problems
- Towing Question
- Dana 30 Disco to Non-Disco
- Winch motor or battery problem?
- Picked up AMC 304 V8 today
- CV joints for the D30?
- a newbie MJ question......
- MJ SOA + ??? coils up front?
- Can You Get a Reciever Hitch for XJs at Wal-Mart???
- U-Joint D35 and 8.25??
- Power tank opinions
- Anybody run these meats?
- Quick Air Where?
- drag link / sway bar link mount interference
- where to get nonresistor bosch plugs
- Aussie Locker for 8.25 29-spline
- another sye question....and rockrails
- T-case noise?
- new 37's came today!!!
- A few questions: suspension, vibe Q's, year specific stuff.
- anybody running Firestone Destination MT's?
- how good is Harry Lewellyn's "advanced 4wd handbook"
- Looking for photos of XJ's on full width axles.
- tranny upgrade?
- I need a 1994 XJ Service Manual
- TJ D35 shafts on a XJ
- Shackle angle in relation to spring pack
- Carrrier compatibility in Dana 30
- hp dana 30
- Rusty's 4.5" Lift
- rockrails choice
- Swamper shipping $$
- Boggers and SSR questions???
- waz up
- New downhill driving technique for auto's
- Up grade steering gear?
- removing the Oem turbo muffler???
- LCA's
- Anyone have Safari snorkel cutout pattern they can email me?
- Carrier changes..
- 8.25 Trac-lok disassembly?
- Making LA's Some ??'s
- Noisy T-case?
- loose magnet in a case iron t-case?
- Anyone here with a HO head on a 87-90 renix
- Tire preservation ?
- Do I keep this?
- Which is the Better Gears 4.11 or 4.56?
- 31" with 2"BB?
- Detroit Locker Prices
- Waggy Axle ????
- how to tell difference in D60 and D70
- Pitman arm nut size?
- New bumpers, rockrails, snorkle and diff guard!!
- Pros and Cons of a D44 spool
- is this dreaded death wobbles???
- Question for XJ Offroaders
- Welded 8.25?
- New "Glow gauge faces"
- How to Choose Shock Lengths
- 92 ABS booster vs. non-ABS booster
- Does anyone use filtermag
- PICS: DIY Hydraulic Assist, Box Modifications, Ram selection, Saginaw Rebuild kit....
- Cage is almost finished!
- nitrogen instead of co2
- Shackle box grinding?
- Beez - One Ton, how much can I cut...
- Lifting from a 3 inch to 4-5 inches
- From 31x10.5 to 33x10.5
- Only two days after roll...
- onboard air bracket (york)
- dana 300 flipping?
- dana 30 lunch-box lockers
- CV Driveshaft w/o sye kit
- Mickey Thompson Baja Radial Mtx Tires
- Ball Joints on Waggy Axle???
- Waggy Seals(this is getting old)!!!
- rear leaf spring idea
- How to measure rims
- Need tips on HUGE conversion...
- Who sells rearend shims???
- D30 High Pinion/Low Pinion
- Advice needed on control arm poly bushing replacement
- D30 LP to HP Swap - which housing?
- Limiting Strap mount
- Trackbar Frame Mount......... Tell me how nuts I am!
- What else could it be..?
- XJ Dana 44 Rear measurements
- quick xj tow hook question
- Anyone Heard or Used this Tires????
- RE LCA Length ?
- Metal prep before welding
- Finalizing 8.8 install...
- Rubicon TJ D44 Front Axle XJ Swap
- torque converter install help
- Dana 44 front axle?
- cheap steering box swap.
- front lockright and 33s one day 35s
- C4x4 rock rails
- Project updates
- Harbour Freight winch vs. Ramsey REP8000
- New bonnet ( hood ) with venting cowl fitted.
- i'm beginning to stroke it
- TJ/XJ axle brackets
- What air press would you guys recommend for 33X9.5 rubber?
- Cobra CB
- what springs
- Shackles
- New article on madxj.com! Air intake mods on '98
- Lock-Right?
- best price on RE 6130?
- Chopping the rear Quarters
- A ? for those who run Bilsteins 5100 and re 5.5
- Which Lift?
- Go Jeep at it again....cowl induction hood
- Gears!!!
- where to get bushings
- Guys with 8lug Ford fronts, need a measurment
- factory spare tire carrier
- Great Exhaust Mod!!!
- RE superflex 4.5 inch lift for 93 XJ
- new steering ?
- 10.25 axle
- What lift components do I need?
- What T-stat should I use stock 192 or lower?
- LeBaron hood vents installed
- What Degree shim to run?
- What exactly could be limiting my flex?
- Injectors (interesting info for nerdy types like me)
- hey ashman
- What type of Rocker Guards??
vBulletin® v3.8.3, Copyright ©2000-2012, Jelsoft Enterprises Ltd.