View Full Version : Modified Tech Discussion
- TJ flares, trimming the rear...& mounting.
- Optima Red Top
- Alignment w/ homebrew longarms?
- One piece header or three piece header??
- re adjustable arms or not
- No 4 LOW
- LTBs
- 2.8 - 3.4 swap - note
- Updating RE 4.5"
- how to take brake drum cover off?
- FINALLY !!! Got some lift...heres the Pics
- Upgrading Chrysler 8.25
- Dana 44 rear brakes, where to get everything?
- Pivoting Leaf Spring Perches ???
- D60?
- ox locker
- Long Arms-To the crossmember or frame brackets??
- worked on my Exo today
- gonna be starting the cage soon, welding ?
- anybody use IPF H4 headlights?
- How to contact Jacobs electronics?
- Sun. update on the POS XJ project
- Which brand subs?
- How many bolts?
- ball joints
- Post gear set up noise question
- oem towhook brackets from an 88 xj
- Lift? Tires? Differential?
- 4wd Vs. 2wd performance?
- tire carriers
- Explorer 8.8's
- Need Ford 9" info, I searched...
- TCU diagram
- leaf spring headache
- Block off kit for 297x axles?
- Fuel gauge help???
- Would these 44's fit a cherokee without trimming?
- Ready to chop my fenders
- Has anyone done this?
- overdrive t-case idea?
- Advance Adapters SYE and Tom Woods CV Drive Shaft
- Atlas Users
- Bulletproof mfg rear bumper dimensions and pics.
- Rear top shock mounting bolts keep coming out
- What are my alternator options???
- GDI or CSF Radiator, which one?
- Oil filter remote
- Ford 9" yoke vs XJ yoke/Ujoint
- d30 conversion
- Shortening the frame
- need so advice
- Water Holes in the Floor
- bridge rail project
- Aftermarket cooling fans
- aircraft sunroof
- Ranger spindles on a XJ/MJ?
- 2" lift blocks
- Tranny fluid
- What do you put in your rear(end)?
- crawling with a AX15...
- It's so tempting
- NP242 TO NP231 swap...possible?
- What do you guys think of the Chrysler 9.25
- New Lift, Anything Else
- Upgrading axles 5 on 4.5 or 5 on 5.5?
- Coilover Spring Calculator
- Removing and Replacing front Crossmember
- Anybody with a Rusty's 4.5" lift on a 98 or newer XJ???
- Bump Stops...
- Rear Bumper
- need tire size opinions
- welding axel
- BigOffroad??
- Ford 8.8
- Aftermarket Shifter for AW-4
- 1" lift block
- Hole in the floor
- CO2 Tank ?
- front spring height
- ford 8.8, dana 44, 9" pinion height???
- bumper questrions
- '97 1-2" lift
- Skyjacker 6" Rock-Ready on an 88 XJ?
- A couple progress pics...
- milage (wear) on TrXus MT's
- looking for opinions
- MJ springs under an XJ
- Tire opinion
- hi everyone!
- Rear bumper saved my Jeep today
- Lockright install on a 8.25 axle
- RE 1660 Measurement (track bar)
- Shock recomendation
- Anti-hijack snow chain post
- front axel question{opinnion)
- Quick Lock?
- Time to remove some 1/4 panel
- front 44 almost done...still steering issues
- UCA bushing part numbers
- Kevin's Sliderz w/ RE drop brackets
- What do you do after the unibody is platted?
- uneven steering
- 85 bumper on a 93
- Drivetrain opinions
- Manual tranny swap Q
- 3:55 to 4:56 - need to change carrier?
- Gearing Questions
- 8.25 Aussie
- Fabtech's new XJ 4" lift
- 3" lift questions
- AJ's Rockrail troubles...
- slip yoke spline count?????
- Death Wobble with new 3" Rough Country
- Cherokee Long Arm Dimensions?
- Which JKS discos to get?
- Stretched Chain in NP231?
- Name that breakage.
- lifting without drop brackets....
- 4wd light basics ?
- Guys runnin 36/37" tires (both w/ stockish and non stockish axles)
- Will 31" tires fit
- Stupid Question Re Shocks
- Unibody platting??
- stock steelies
- xj death wobble
- lca bushings
- Sounds stupid, but will it work?
- Anyway to intall dual stabilizers
- I6 MSD ignition questions
- bump stop hitting spring
- Best Non-HD SYE
- 3" lift vibrating from the rear help?
- cv driveshaft question
- Buskwacker Flares and 31x10.5 BFG's
- D60 Blue-joints....anyone seen these yet?
- Re-gearing diiferential
- Left and Right Motor mounts the same?
- Ford 9 disc brake conversion
- 33" tire question SSR's and TRXUS'
- Tennessee offroad roll cage anyone running it?
- column shifter for AW4 auto tranny?
- 4wd to 2wd problem
- 89 XJ, I want to remove as much as I can under the hood...
- 44s comparison
- Who has 3.73 gears for 8.25 rear?
- Hurst shifter for AX-15
- Potential Diesel engine?
- Switchable ABS
- Lift Questions on RE and Rusty's
- comanchee
- Pilot bushing/bearing question on BA-10/ax-15 swap
- 91 Cherokee Auto 33's need gearing?
- axle or drivetrain upgrade....help me
- Question about ABS
- Trans Damage on 33's?
- First post ... experienced Jeeper, new XJ owner, need tech
- Mountaineer Rack?
- Wagoneer D44's
- To Beadlock or Not???
- U-joint going bad - how much time?
- finishing build-up (fow now) need advice
- AW4 21sp to 23 spline
- Cherokee SUT
- 44 direct swap in?
- 88 XJ Front Axel
- C4x4 Rear Bumper question
- Idea on wiring multiple aux. lights
- ORGS TB Axle-End Mounting-What's Going On??
- Toyota 8.25" rear axle swap
- hack-n-tap vs. new shaft sye
- Engine Mount Gurus...
- BIG FOOT XT's 33X9.5 has anyone used them?
- Engine Swap
- 2000 XJ w/ABS Differential & Lift Help
- Bright ideas
- Superwinch hubs vs. Warn
- anyone did a remote fuel door opener mod?
- Re-Gearing a c-8.25 29sp & d30 from 3.55 to..
- high amp altenator
- What spare parts to carry on the Trail?
- Rebuilding Dana 35
- Who runs one UCA?
- Pics of hack and taps
- Getting ready for full width
- bolt on LA kit
- Opinions on Pacer Rims?
- fender trim edging
- Aw4 buildup / shiftkit?
- Low pinion D30
- Posi Lock
- What is Your Lift Configuration?
- Left tire rubbing LCA. Tips?
- '99 front axel into '92 Brake questions?
- Moron (I mean "more on") subframes...
- This may be a totally off the wall question
- Re 6139 4.5" w/Rancho RSX's ... weird noise
- Who's actually run 33s, 4:11s, and an auto?
- Buying new tires...road hazzard??
- D44 swap front and rear parts?
- What the heck was that...?
- 15" or 16" wheels?
- Anyone done this high steer setup?
- 6"-7" lift
- what happned to the bolt in roll cage??
- alternator upgrade
- How much does your XJ weigh?
- quick Q
- Rokmen
- New to the XJ thang.
- Seat swap?
- Pre-runner clip....
- Radiator Replacement: Need your wisdom
- '93 4.0 manual. Gear swap 3.07 to 3.55
- wheel questions
- building long arms
- EXO cage's...again!
- 50% done with half of my LED tail lights.
- RE 4.5 measurements
- aussie locker shipping Times
- Rear Coils Questions
- Leaf spring break in advice
- How Can You Determine if You Have a Limited Slip or Open Differential
- 4.2 block w/ 4.0 head, intake, exhaust
- Better ways to attach the interior hatch cover
- OME Nitrocharged Shocks
- lift, tire, wheel, SYE dilema!!
- What to do with extra space under the hood?
- Fittin' 35's on only 6" of lift????
- Aftermarket D44 shaft options
- TRE vs HEIM ...
- Swing-out Biggest tire
- AW4 help needed, do I need the kickdown cable if I'm shifting electronically?
- Is it worth it?
- swapping in an aw4.........
- first sec. of accel. vibrations....?
- A small AW4-quirk...
- 33x10.50R15, 4.11's AUTO????
- Is this guy posting spobi!
- My Cage is done, what do you not like, suggestions.
- lockrite ?
- Diff'rent Dana 30's...
- Gambler owners
- CA Exhaust Question
- AW4 solenoid help?
- 304 v-8 in a cherokee
- ABS Removal
- Replacing UCA, Any Suggestions?
- Kumho Tires (Ridge Runners) Good? Bad ?
- Roof rack tubing size?
- Full guage cluster?
vBulletin® v3.8.3, Copyright ©2000-2012, Jelsoft Enterprises Ltd.