View Full Version : Modified Tech Discussion
- Does anyone use Offset Leaf Perches?
- M35 super Eliminator kit?
- APN header won't fit Renix
- Leaf springs moving....
- 92 Alternator Upgrade ?'s
- Correctly seating coil springs on axle
- upper control arm bushing alternatives
- New XJ, looking for advice
- Do I have death wobble? (XJ Newbie here)
- Bought new to me/used Aussie, opinions on condition of it
- Header cracked, could hurt valves?
- castor angle on 6.5 in. lift ??
- New XJ and need to replace the rear main
- snorkels anyone?
- Where and how did you mount your Magnefine filter?
- front winch bumpers?
- Button-on Canvas windows/tops
- Thoughts on Warn 10000 winch?
- Jeep Xj Control arms affect alignment?
- Finishing front suspension, have track bar install questions
- Steering Upgrade for 2" Lift
- Anyone with HD engineering stiffeners have a JCR tcase skid?
- Removable doors. Light?
- D-ring or tow hook
- PSC Box Ram Assist... Which line where?
- D-ring tab hole size.
- APN header for 01...?
- hack n tap install
- Looking for 89XJ suspension upgrade
- water temp. sending unit location??
- XJ Bumper
- Winch remote
- Heim/TRE/DOM Steering
- xj steering
- Steering box advice
- up travel vs down travel
- 4wd light is flickering on and off
- ? Best master cyl for brakes D44HP & D44 axle upgrades ,brake pad ?
- strange steering
- heat wrap the cat
- Homemade disco's (w/ pics)
- Long arm vs 3 link? time to decide
- Tap a housing?
- lift height
- 4" BS in 17x9 or 17x8 size?
- Rear bumper mount holes?i
- Dirtbound Hack-N-Tap problem installing
- need help deciding?? LCA and spring
- installed my OME lift, question regarding coil spring length
- How many people have detroit lockers for the 8.25?
- Axle swap questions
- Interchangeable engines?
- hi clearance exhausts, who's got 'em?
- drive shaft
- Yet another brake booster swap question...
- some advice
- Speedometer Correction
- Rubicon Express 3.5" leaf length?
- wiring LED lights for 1/4 panel armor?
- ford rear 8.8 swap/conversion
- Oil drain plug not lining up with skid plate hole.
- T&J frame stiffeners and long arms
- engine seems to skip
- d44 and d35 drum swap?
- speedo gear
- how to get Idle Air Control plug to fit on late model intake
- OX or ARB
- 4.5 coils
- Snorkel
- 16 wheels to 15 inch?
- Oil cooler - anyone done it?
- D35 -> 8.25 swap parts?
- Let's play "What's that Awful Sound?"
- Spartan locker won't unlock
- 4.56 or 4.10 gears for 31" and dual purpose XJ?
- Dana 300 in a 98
- Odd gas saving mod...
- where to buy custom size steel wheels
- Rebuilt steering gear choices
- 8.8 brakelines ?
- cut mod for sye
- cantilever suspension
- aluminum heads
- emergency brake swap
- ZJ tie rod question
- Rocker/Slider Question
- Using 2dr bushwackers on 4dr
- Has anybody tried using a caravan coil pack on a 2000-2001?
- hack n tap install
- Bilstein 7100 valved 150/50?
- not a, what gears should i get? gearing question
- yj bracket a/c compressor issues
- The "you already have a relay box" Relay Box
- powertrax no-slip install?
- STEERING ISSUES
- What Rotors? ZJ Discs on XJ 8.25"
- Team NAXJA/Petty Cash Racing stock class KOH XJ build
- Upgrade to Aftermarket Axle (VERY large Budget)
- Full frame
- U-bolt Retainers for U-Joints
- THOR Cowl Induction System Installation guide
- waggy D44 swap
- Speedo healer
- Rear 4 link on exo?
- boomerang shackles and relocation?
- 4 into 2
- Lift kit Questions
- TNT longarms and CA skids.
- ALUMINUM WHEELS WITH 4.5" BS where to find?!!?
- My weekend Projects started Thursday
- Ford injector upgrade help
- The Infamous "Front Spring Measurement" question?
- Piecing together a 2" lift...
- Smoothest Riding 3" to 4" lift for XJ? All imput welcome!
- PSC steering pump for 97-up XJ: part number?
- Which end?
- 4.5-5" lift
- Driveshaft question
- 37s 4.56s or regear to 5.13s
- 91 xj slip yoke question
- Want to be weird!!
- Master and Slave cylinder questions
- 8.8 swap i have e brake questions
- need some info CSF radiator
- need better braking!
- lateral shackle angles?
- Swapping HP d30 for c200f?
- power steering pump question
- Drivetrain angles... I know, its different
- Anyone running these HID's?
- Installing RE H&T Tomorrow
- Brakes
- APN Header + CA Smog = ??
- xj axle swap and abs
- skook xj build
- Leaking axle seals in chrysler 8.25
- Hi-flow T-stat Housing
- Death Wobble 87 Jeep Cherokee
- opinions on lift kits
- Rear set up advice
- What's the best vehicle and year to get a dana 60 from?
- POWERTRAX® No-Slip in a Dana 35, Sand and Mud
- Pre-95 Seat swap...
- OME long travel shocks
- A Frosty axle swap thread
- Treadwright Buyers: BEWARE. Pics inside...
- 4.7 stroker electrical problms
- Cut lift spacers?
- What size bolts for a winch bumper?
- Bushwacker Flairs
- Motor Mounts
- Shocks with heim ends clunking?
- My Dyno results
- Does size matter
- Vibration issue!!!!
- Axle chart?
- Which Front Locker
- Bastard lift parts for 5.5" lift
- a/c compressor bypass
- 241D Transfer case behind an AW4?
- The Glove Box Relay / Fuse Panel Build
- Project RollingWreck
- Nitro Super Joints?
- roof basket
- alignment
- BFG KM2
- Shackles angled forward rough country 4.5
- Five volt live line
- Dana 44 Regear / Carrier Question
- max lift with stock shocks
- easy hp?
- Extended rear brake hose?
- Where to get drive shafts?
- Help and opinions from you pros please
- What size tire will fit with 4'' lift?
- Coil upper retention?
- Adam's 98 5-speed Build
- Rough Country Series 2 3" lift, bushwhacker cut outs, and other Q's
- Alternator"proof of mud"
- SYE and rear end questions
- Disable both airbags on 2000 XJ
- Stock-Length Control Arms
- sloppy otk steering
- abs vs non abs axles
- Mystery/prototype Rustys Trac Bar
- Clearwater Cylinder Head (0331 replacement) Questions
- looking for a new steering setup, any ideas?
- Tore my unibody
- brake booster upgrade?
- Superlift "Superide" springs....
- Gen-Right steering pulley vs. OE
- Custom Trackbar,,, Bushing AND/OR rod end??
- control arms
- How to Wire Off Road Lights?
- 1998 Cherokee trans problems
- tint or not to tint, that is the question.
- 4.0 Stroker Questions
- Rear flex
- teraflex hand throtle
- Moving the tranny cooler
- Rebuilt motor isn't running right.
- Currie doesn't make their own shackles?
- Axle shim question? No not pinion angle thread
- ZJ front coils will add ___ inches
- Ota trackbar bracket
- 4.0 rebuild?
- any install pictures of a box4rocks?
- brush guard?
- Weird front tire wear
- Price range to regear axles?
- Clayton Offroad XJ 8" Coil Conversion Long Arm Lift
- Planning major fix - Front-End suspenshion
- Highest compression ratio?
- Opinions on new header
- Wheel adapters and spacers.
- Got some $$ need new shock ideas?
- help installing cb radio
- H3 light bulb
- need some advice for coil rear end conversion
- my 91 xj build thread
- Rough Country Winch Bumper Pictures
- which coilover shock to replace rancho
- Drop Pitman
- C8.25 Locker
- New Shackles vs Shackle Relocation brackets.
- Bought tires... Need lift.
- Taking the manual conversion skydive
- My 1994 XJ
- AW4 trans control idea
- How to measure pinion angle?
- rear bumper build
- just had alignment done after lift, serious caster changes made. what you guys think?
- 3.5" lift, currie steering, feels like slight bump steer, ZJ pitman arm??
- JCR Nutstrips, do they need paint?
- ram size for hydraulic assist
- Questions about Howe Clutch Master
- Remote car starter and neutral safety switch
- Rebuild and Customize or to Buy Reman'ed Xtransfer
- Project Budget Build
- Can you ID this roof Rack? Post pics of your rack please.
- Rock krawler 3 link question
- Wiring up JCR LED lights
- 242 shifter problem
- Rhino Line on winch mount bumper?
- Advice on Chevy 4.3 into 88 XJ
- Custom Trackbar..where to bend?
- which lift for a dd/child transporter?
- Do I need shims?
- Help me ID some aftermarket parts
- 231 tcase w/242 aw4 tranny??
vBulletin® v3.8.3, Copyright ©2000-2012, Jelsoft Enterprises Ltd.