View Full Version : Modified Tech Discussion
- ABS Removal
- Vacuum disconnect D30 spline count
- APN header require altering to fit my '99?
- Finished D44 swap, now I think there is a whirring sound...
- Info for RE long arm suspension install
- Question about lift.....First post
- How to Run Exhaust
- Bits of Advice
- My ring and pinion research thread
- cheap xj snokel
- New Bumper Design (pics)
- going from 3.5 to 5.5
- 8.25 27 or 29 spline
- PA speaker
- 2x4 to 4x4 questions
- hei on a 4.0
- Flexing to figure shock length.
- Replaced exhaust manifold, start engine and the RPM's go out of control!
- Dana 60's Or build my axles
- JK Dana 44 Elctric Locker
- Roof Cargo box Options?
- Suspension question
- front driveshaft vibrating
- FOX 2.0 RR rebuild pics + shock oil question.
- SS Brake Lines Question
- Good headlight harness?
- Socket size needed for shackle bolts?
- Why is my gas mileage so bad
- 35" tires + stock steering OK or NO GO?
- Factory LSD Trak Lok Transplant
- good friends with bad luck
- what else do i need for 3" lift
- Anyone running 4.10's and 33's.
- Built a subwoofer/gear storage cabinet for the back of the XJ...
- 38's....
- grinding noise i cant figure out!!??
- STIFFENERS QUESTION
- Winch line speed
- Late dash into early XJ...I did search.
- South American XJ D44?
- New Walker Downpipe vibrating on crossmember.
- Install instructions - TNT Inner SB Brace...?
- Need Shock Help...Not Enough Droop.
- Offset axle in the rear
- Cargo Area divider
- Stuck aftermarket shocks
- best performance mod for the money
- Can 32's run on a 3" lift with trimming?
- pics of projects in progress (cargo area, console and lower door panels)
- Upper Control Arm Bracing?
- Cutting off Inner C's: Need Advice
- steering upgrade questions/brake booster
- Oil Filter Adapter Upgrade
- Mj rear radiator
- purpose of dropping pitman arm?
- Vibration/Noise issue solved!
- Larger/Auxiliary fuel tank for 99XJ ?
- 1986 Tire Carrier onto 01 XJ ?
- TRE to Heim conversion
- spring hanger help
- Question about Drive Shaft and lift???pics..plz help
- Here's a challenge for you... mounting a snow plow on my XJ w/ an ARB bumper???
- Gear question
- Difference between RC's 8000 and 9000 series shocks?
- Axle help
- Tera Flex Disc Kit for 8.25 questions
- Is there a full circle clips how to?
- Help Level My Jeep! (Pictures)
- Rusty's or YJ/KJ steering
- UCA Mount Brace
- Would you rather mod a 2000XJ or a 99 XJ ?
- Review: Treadwright BFG A/T 30" retreads.
- control arms with an OME lift
- Dana 44 brake setup
- One-way drive shaft or differential?
- Maximum tire size with least amount of lift
- Hankook RF10's A/T tire
- Opinions wanted on gauge placement
- Anybody used rough country's 4.5" lift?
- WJ pitman with WJ knuckles
- alloy axles
- RE 5.5" w/ stock control arms?
- Divorced? What to do?
- differences in doors?
- 8.25 gear install gone bad..
- UCA Bushing
- gonna buy a lift kit tonight, recommend one
- 4" or 4.5"
- TRE's explained?
- e3 spark plugs
- Clunking when in 4x4
- LED Stop Turn Tail / Wiring Question - Searched = dead ends
- i need end links for RE Gen 1 sway bar disconnects?
- grand cherokee alternator?
- 242HD Transfercase?
- Shop wants $850 an axle to regear....
- ring gear carrier, bearing removal
- So I rolled the XJ
- Front bumpers!
- 242 and no power to front axle
- How many hockey pucks??
- maxxis bighorn VS hankook rt03
- Aussie locker
- PVC/ ABS snorkle....anyone concerned about the 175 degree F melting point of PVC
- ECM fuel map question (guru needed)
- Does a TC master rebuild kit contain a Rear output seal?
- Modified braking question
- aussie locker help
- 97+ steering wheel aftermarket install
- Starter Relay Bypass
- TRE thread engagement to tie rod
- Fabricated rear bumpers
- home made long arm suspension
- brake convesion on 8.25
- Frame stiffener install pointers
- swayaway shocks
- No drive after 242 to 231 swap?so weird
- tnt truss and steering stabilizer
- Tantrum LED rock lights
- Pop noise from leaf springs ???
- whirling sound in driveline
- ZJ e fan
- Whats a good Battery for winching
- suggestions for new radiator (upgrade?)
- how to tell the difference between 27 or 29 in 8.25
- Rusty's air tube install question
- waggy dana 44
- ARB Issue
- XRC 8000 or 10000
- carrier bearings
- pro comp lowers, or stock?
- TNT customs front truss
- RE Track Bar Brace
- 1 ton steering question
- old to new ebrake cables..
- Installed 95+ booster, need brake line size
- XJ Steering Box Upgrades?
- Which long arm lift kit is the best buy ?
- XJ Steering Box Upgrade?
- Puma Air Compressor for OBA
- Black H4 headlight kit
- 15X8 BS: 4.75, 4.00 or 3.75
- getting RE3.5 in lift, which shocks go best?
- Should i be concerned??
- bought a used RK 3-link
- RK 2009 long arms...
- Need advice on brakes!!
- vibes after skid install
- Getting more flex from my rear leaf springs?
- sounds funny
- Problem!!
- JB Conversions SYE
- Front End Noise after Front Locker Install... Stumped
- need new steering box
- Homemade Bumper
- Transfer Case Linkage
- AJs Rock Rails
- Roxolid Trail Armor?
- Big Daddy tie rod issues!
- What year ZJ to part out?
- Doorless people: Speakers in kick panel
- JK Rubicon Shocks
- ax-15 swap questions...
- rebild 4.0L
- 8.25 yoke Q
- Question for the gear guys
- 90 limited budget build
- getting new tires, tell me which is better between this
- wiring up LED STOP TURN TAIL For light boxes Thor guards (w/pics)
- Twin Motor Warn 8274
- Superior 8.8 kit
- Yakima rack round bars...make your own?
- Options for exhaust. Just need opinions.
- Exhaust???
- LG on the back of the Instrument Cluster
- My poor man's toolbox
- my brake switch after 95+ xj booster upgrade
- Driving Lights wiring question
- Shocks
- Manual to Auto conversion
- Is the TNT belly pan supposed to come with hardware?
- What are you running as your front driveshaft?
- Galled TRE threads, what now?
- 5.38 vs 5.13 strength comparision
- Ford 8.8 E-brake Cable Write-up
- alternator relocation -- with PICS! finally
- Trac-Bar help?
- Young'in looking for some criticism on setup?
- dt8000s?
- SYE and driveshaft question
- YJ front D30 any benefits?
- 2000 242 t-case tailshaft install questions
- Need Help to identify my Locker and lift
- np231j vs np231
- More lift
- No oil on start-up
- need some fabbing help
- Manual Switching of the auxiliary fan
- Long arm joints
- doing my front end, need CA lengths
- problem wiring DPDT switch for Hella 500's
- weld on bead locks
- steering kits...why the price difference in these 2
- Differential Setup Specifications
- making a roofrack, how do i make gutter mounts?
- Long Arm Suspension cons
- WJ knucle swap
- Cheap shock for 3" lift (front and back)
- air shocks
- Switching around fans?
- Is there a all around tire for my use?
- braking problem
- Why all the TSL SS Bogger hate?
- winch mounting
- Need help on winch bumper
- LED front markers
- RE6130 Shocks
- will someone please help??
- what all fits on a 90 renix of the 99+ motors
- gauge help!?!?!
- detours tailbone
- 242 input spline count
- 34x9.5x15 tsl "pizza cutter" rim size
- Trac bar
- How long should my lower control arms be?
- Auxillary reverse lights wiring help
- trac bar fab
- 8.8 parking brake cables
- The Great Debate
- I have issues
- Gears and stress
- Rust's Bar Pin Eliminators
- 8.8 ebrake lines....how to
- Diff cover wrench?
- Rear Stinger
- Cherokee center cousle upgrade!
- My frontend pops under hard steer
- Crank Position Sensor
- front driveshaft
- Retreads???
- rustys or 1source adjustable front coil spring spacers
- DPG belly skid: every single bolt is stripped. Body flex?
- recommendations appreciated
- Rear End Question
- Need some search help
- BDS trackbar part # help?
- Welding to leafspring pockets
- dropping tranny...horrible leak, what seals to replace
- New edelbrock header for 00-01 4.0L
- 760x Ujoint Part Number @ Napa
vBulletin® v3.8.3, Copyright ©2000-2012, Jelsoft Enterprises Ltd.